saxby IM-91237 Recess Clip Electrical 4 Less Instruction Manual

June 12, 2024
saxby

saxby IM-91237 Recess Clip Electrical 4 Less Instruction Manual
saxby IM-91237 Recess Clip Electrical 4 Less

Thank you for purchasing this accessory. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. Please retain these instructions for future reference.

Installation

This recess clip is designed only for use with Sirio panel and  Stratus panel. Read these instructions before commencing installation & retain them for future reference.

  • Note that the switch is turned off before installation.

  • There are two kinds of the screws supplied in the bag
    size: 04 x8mm is suitalbe for Sirio panel; size: @3 x 6mm s suitalbe for Stratus panel.

  • One set accessory required for size is 595mmx 535mm panels.

  • Two set accessories (6pcs) required for length 1195mm panels.,

Installation diagram for Sirio panel

Locate 8 captive its in the tear of the panel frame, 4 on opposite sides.
Installation diagram

Screw the spring clips to the captive nuts using the screws provided, spacing as required for the installation

Cut a 570mm x 570mm hole in the finished ceiling, taking care not to infringe on services within the void.
Installation diagram

Connect the LED driver to the mains supply following the installation guide supplied with the LED panel. Push back two springs on one side of the panel and slot into cut out, finish by repeating on the second side.
Installation diagram

‘The LED driver can sit on the rear of the panel once installed.
Installation diagram

Tum on the power and test the LED panel
Installation diagram

Installation diagram for Stratus panel

Take off screws from the back
Stratus panel

Screw the spring clips to the right position using the new screws offered.
Stratus panel

Cut a 570mm x 570mm hole in the finished ceiling, taking care not to infringe on services within the void.
Stratus panel

Connect the LED driver to the mains supply following
Stratus panel

Connect the LED driver to the mains supply following the installation guide supplied with the LED panel. Push back two springs on one side of the panel and slot into cut out, finish by repeating on the second side.
Stratus panel

Turn on the power and test the LED panel
Stratus panel

Recycling advice

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.

Safety information

For your safety, always switch off the power supply before cleaning.

V22111072019
Saiy Lighting. BH17 78Y

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

saxby User Manuals

Related Manuals