NODOR WP-1500 Built In Warming Drawer Instruction Manual

WP-1500 Built In Warming Drawer
Instruction Manual

IMPORTANT INSTALLATION INFORMATION

Please read this instruction manual carefully. This will allow you to use your appliance in complete safety.
Always keep the instruction manual handy.
This appliance is exclusively for home use for heating dishes.
The manufacturer shall not be held liable for damage to persons or property due to incorrect installation, or inproper, wrong or ludicrous ues of the appliance.
Be sure to check the appliance once it has been unpacked.if it has been damaged, do not use it.
Contact customer technical service.

PROPER USE OF THE APPLIANCE

This appliance is compliant with current safety regulations.
Improper use may nonetheless cause damage to persons and/or property.
The inside of the appliance ma reach a temperature of up to 75 ℃ when the thermostat is set to the maximum position. When taking out hot dishes, use appropriate kitchen mitts as necessary.
Remember that children have very delicate skin which is more sensitive to heat.
Therfore , do not allow children to play with the appliance.
If the on button is pressed , the drawer will start heating and there is the danger of burns.

SAFETY INSTRUCTIONS AND WARNINGS

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not use the appliance to keep warm , re-heat or cook foods and beverages.
Humidity from foods or beverages may cause problems for the appliance.
Do not lean or sit on the open drawer.The telescopic carriage may be damaged.
The maximum load of the drawer is 25 kg .
Make sure that the appliance is firmly secured to the cabinet.
Do not keep plastic or flammable objects in the appliance.
When the appliance it turned on, these kinds of objects may melt or catch fire.
Fire hazard.
Do not use the appliance to heat the room.
Never use steam cleaners. They may cause short circuits and damage the appliance.
Never under any circumstances insert objects (e.g. screwdrivers, pointed objects, paper, etc.)
Through the slots in the protection grille of the heating element and fan.
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

DISPOSAL OF PACKAGING

The packaging materialls protect the appliance during transport.
Recycling of the packaging makes it possible to save raw materials and reduce waste volumes. If you dispose of the packaging yourself, ask local authorities for the location of the nearest collection centre.
DISPOSAL OF ELECTRICAL AND ELECTRONIC APPLIANCES
This appliance is marked according to the European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health. Which could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste . Instead it shall be handed to the applicable collection point for the recycling of electrical and electronic equipment.
Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about the treatment, recovery and recycling of this product , Please contact your local city office, your household waste disposal or the shop where you purchased the product.

ELECTRICAL CONNECTION

Contact a qualified technician for the electrical connection of this product.
Before connecting the appliance to the electrical mains, ensure that the technical data (voltage: V and frequency: Hz ) in dicated on the plate concur with those of the electrical mains.
If in doubt, contact a qualified technician.
If the plug is disconnected from the electrical power cord , a qualified technician will be required to insert and connect the qppliance . Contact a qualified technician who is knowledgeable of local standards and of any additional regulations issued by the lacal electric company , and who ensures that work is carried out in compliance with these standards.
Important: check that the appliance is correctly connected to an approved earth wire to ensure electrical safely. If necessary , have the system checked by a qualified technician. The manufacturer shall not be held liable for damage to individuals or property due to lack or interruption of the earth wire.
Attention: earth connection is required by law.
If the appliance is connected to the mains with an extension cord. Make sure that the extension cord and the connection are insulated against humidity.
The appliance is manufactured use only after being properly inserted.
Never open the covering of the appliance if you come into contact with wires that carry volatage or if you modify the electrical and mechanical structure of the appliance , it is possible that the appliance will malfunction during operation.
If installation, maintenance andrepair work is not carried out correctly, there may be hazards for the user . The manufacturer declines all liability for this type of personal injury or property damage.
During the warranty period , repairs may be carried out by authorised technical service staff. Otherwise, guarantee coverage will be void.
Installation, repair and cleaning work are to be carried out only with the machine disconnected from the electrical mains. The appliance is disconnected from the electrical mains in the following cases:

• the main switch of the electrical system is off.
• The safety switch is off.
• The appliance is unplugged.

When unplugging the appliance, do not pull on the cord. Take hold of the plug.
It is advisable to connect the apliance to the mains with an electrical plug.
This will make technical assistance easier should it become necessary.
Make sure the plug can be reached after the appliance has been inserted.
If connection is not made by means of an electrical plug, contact an electrician who is knowledgeable of local standards and of any additional regulations issued by the local electric company, and who ensures that work is carried out in compliance with these standards.
If the electrical outlet is no longer accessible after insertion, or if a fixed connection is to be made, the installer must provide a separation device for each pole.
Valid separation devices include switches with a contact opening of at least 3mm.
Data required for connection can be found on the data plate. This information must match the data of the electrical mains.
The manufacturer shall not be held liable for damage to persons or property due incorrect installation, or improper, wrong or ludicrous use of the appliance. The manufacturer shall also not be held liable for accidents (e.g. electrical shock ) caused by lack or interruption of the earth wire.
After assembly, all parts of the appliance must be insulated so that no mishaps may occur during operation.

USEFUL INFORMATION

The appliance is designed exclusively for the heating of dishes which are suited for this purpose.
The appliance is equipped with a hot air system. A fan creates excellent distribution of warmth from the drawer heating element. Air circulation heats the dishes evenly and quichly.
A protection grille prevents contact with the heating element and the fan.
The base of the drawer is coverd with anti-ship material to keep dishes from moving when it is opened or closed.
BEFORE THE FIRST USE
When using the appliance for the first time. Clean it as follows:
Clean the surface with a soft cloth and then dry it.
Pre-heat the empty drawer for at least two hours. Tum the temperature knob to the maximum setting, in order to eliminate any residual grease, oil, or manufacturing resins which may cause unpleasant odours during heating.
Air out the room.
Upon completion of this operation, the appliance is ready to be used for the first time.

APPLIANCE CONTROLS

The control elements are the temperature knob and the luminous ON-OFF switch.
With the switch pressed (position 1) the drawer is on, whereas when the switch is released (position 0) the drawer is off. These parts can be seen only when the drawer is open.
When the drawer is closed, a control light located on the front of the appliance lets you see whether the drawer is on.

OPERATION

• Place the dishes in the drawer
• Select a temperature
• Turn on the appliance; the switch will light up
• Close the drwer gently
• Turn off the appliance before removing the heated dishes.

TEMPERATURE SELECTION
The temperature knob lets you select a temperature between approximately 30 ℃and 75 ℃.
Turn the temperature knob clockwise only. Untilthe stop that indicates the maximum setting, and then coumter-clockwise.
Do not force it beyond the stop, otherwise the themostat will be damaged.
The temperature scale does not show absolute temperatures in ℃,but rather symbols that represent the best temperature for respective groups of dishes:
-(cup)approx.40 ℃
For cups or glasses.
When contained in glasses which are previously heated to this temperature , hot beberages do not cool so rapidly and the container can nonetheless be touched without any problem.
-(plates)approx.60℃
For dishes.
Foods placed in these dishes will stay warm longer.
Depending on personal sensitivity, the containers can be touched touched without any danger. Use mitts or pot holders as necessary.
-MAX approx. 75 ℃
For dishes.
The thermostat is set to the maximum temperature.
The containers can be touched with appropriate mitts or pot holders.
HEATING TIMES
The time required to heat dishes, glasses and so on depends on several factors:

• Material and thickness of the dishes
• Amount of load
• Arrangement of load
• Temperature setting

For this reason it is not possible to provide absolute information.
It is advisable to determine the best settings for your needs based on practical Experience.

Load capacity depends on the height of the apppliance and the size of the dishes.
The following examples are approximate.
Also remember that drawer can sustain a maximum weight of 25kg.
Dishes for 6 people:

Or a choice of:

80 espresso cups
40 cappuccino cups
30 glasses (grog)|
18 soup dishes| ￠22cm
2 soup bowls 21cm X 18cm|

CARE AND CLEANING

Cleaning operations are to be undertaken only when the machine is disconnected from the electrical mains. The appliance is disconnected from the electrical mains in the following cases:

• the main switch of the electrical system is off.
• The safety switch is off.
• The appliance is unplugged.

When unplgging the appliance, do not pull on the cord. Take hold of the plug.
Clean all surface with a soft sponge, a bit of detergent and lukewarm water.
Then dry all surfaces with a soft cloth.
Important: the area of the grille for the protecion of intermal components and the area of the switch and themostat must not be cleaned with water.
Any penetration of liquids or other substances into electrically live parts may cause failures or short circuits, creating hazards for the user.
Appliances with stainless steel front
The front of the appliance is easily scratced.
The steel surfaces should b cleaned with a special non-abrasive product for steel.
Do not use:
Detergents that contain soda, acids or chloride, abrasive detergents (powder or cream) abrasive sponges (e.g.steel wool pads) or sponges that contin residual abrasive detergent.
Anti-slip bottom of draer
The anti-slip bottom of the drawer can be cleaned for thorough cleaning of the drawer The bottom canbe hand-washed with warm water and a gentle detergent.dry thoroughly afterwards.
Put the anti-slip bottom back in the drawer only when it is completely dry.
WHAT TO DO IN CASE OF FAULT
Repair of electrical appliances is to be carried only y qualified, authorised technical staff.
Improperly or incorrectly performed repairs may create grave hazards for the safety of the user.
If the dishes are not warm enough, check whether:

• the appliance is on
• the right temperature has been set
• the heat outlets have been covered by large plates or bowls
• the dishes have been heated for a sufficient period of time.

Various factors affect heating time, for example:
Material and thichness of dishes, size of load, arrangement of load, temperature setting.
Optimal heating times for dishes are subjective. Therefore, it is advisable to determine them on a trial and error basis according to your own preferences.
For the following problems contact a qualified technician or technical service:
If the dishes do not get warm, check whether:

• there is fan noise: th fan is working, but the heating element might be defective
• if the fan is not working, it may be defective
• the main switch of the electrical system is off.
• the electrical power cord is unplugged or damaged

If the dishes overheat:

• the temperature setting device may be defective

The on/off switch does not light up when th appliance is switched on:

• the control light of the switch is dfective.

INSTALLATION

Safety instructions for installation
Before connecting the appliance to the electrical mains, compare the connection data (voltage and fraquency) indicated on the data plate with the data of the electrical mains.
The data must match, otherwise the appliance may be damaged.
If in doubt, contact a qualified technician.
Make sure that the electrical outlet is easily accessible even after the appliance has been inserted.
The dish warmer can only be inserted with other appliances with a maximum weight of 40 kg that are provided with adequate cooling ventilation.
If the warmer drawer is combined with other appliances, this voids the guarantee, sinceproper use is not ensured.
For installation of the combination apliance, follow the instruction in the relative us and installation book.
Insertion and installation of this appliance may be performed by qualified personnel who ensure safe operating condition.
Insertion space measurements
The dimensions of the housing are obtained from the size of the warmer drawer plus measurements of the appliance combined with it.
All measurements are indicated in millimetres.

TECHINCAL DATA

Total power: 380-460W
Connection and protection: AC 220-240V/50 Hz
Installation Dimension

CATA ELECTRODOMESTICOS, S.L.
Oficinas: c/ Anabel Segura, 11, Edif. Al 3a pl. 28108. Alcobendas. Madrid. Spain
Fabrica: c/ del Ter 2, Apdo. 9. 08570. TorellO.Barcelona. Spain
T. +34 938 594 100
Fax +34 938 594 101
www.cnagroup.es
cna@cnagroup.es
Atencion al Cliente: 902 410 450/+34 938 521 818
info@cnagroup.es
SAT Central Portugal: +351 214 349 771
service@junis.pt

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>