saxby 73534 EcoLinear LED Batten 22W 1500mm Instruction Manual
- June 13, 2024
- saxby
Table of Contents
saxby 73534 EcoLinear LED Batten 22W 1500mm Instruction Manual
Warning
TThis power supply is Double Insulated and does not require connection to an Earth circuit
Please read these instructions carefully before commencing any work. This unit must be fitted by a competent and qualified electrician. Check the pack and make sure you have all the parts listed. Install in accordance with the IEE Wiring regulations and current Building Regulations. To prevent electrocution switch off at mains supply before installing or maintaining this fitting. Ensure other persons cannot restore the electrical supply without your knowledge. If you are in any doubt, please consult a qualified electrician. This light fitting should be connected to a circuit with a 30mA RCD fitted. If replacing an existing fitting, make a careful note of the connections. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.
Installation
This power supply is Double Insulated and does not require connection to an
Earth circuit. Existing fittings must be completely removed before
installation of a new product. Before removing the existing fitting, carefully
note the position of each set of wires.
Note that the switch is turned off before installation.
The mounting surface must be flat and smooth to ensure a good fit.
- You have correctly identified the wires.
- The connections are tight.
- No loose strands have been left out of the connection block. Check that… Wiring
- Remove to two plastic fixing brackets from the back of the batten.
- Hold the brackets in place on chosen mounting surface and mark the position of the fixing holes. Ensure the correct distance is measured between the brackets and ensure the product hangs level.
- Ensure the ceiling or wall is capable of holding the weight of the product and then fix brackets in place.
- Take care to avoid damaging any concealed wiring and pipes. The correct fixings should be used for brick, cavity walls or plasterboard.
- Unscrew terminal block casing adn connect the supply cable to the terminal lock as detailed wiring diagram.
- Clip product back onto fixing brackets by pushing until securely held.
- Replace fuse or circuit breaker and switch on. Your light is now ready for use.
Layout
Plan the desired layout of these fittings carefully, ensuring the cables will reach the distance between the junction box and the light fitting. Avoid locating any cables in positions that would cause a hazard. Position cables away from areas where they may be at risk from being cut, trapped or damaged. The mains supply cable must have a minimum cross sectional area of 1.0mm2 Cables must be protected using suitable conduit or plastic trunking.
Wiring
This product is double insulated and must not be earthed. If there are any incoming earth cables, they must be joined together and well insulated with good quality insulation tape. This is to ensure earth continuity throughout your property.
Having correctly identified the wiring from your existing light fitting and
connect to the connection block inside the product in the following way
heck that…
- You have correctly identified the wires.
- The connections are tight.
- No loose strands have been left out of the connection block.
Technical data
Supply Voltage: 220-240 V~, 50 Hz
Bulb: 73534 – 22W LED module (SMD), 4000K
Type: 90129 – 18W LED module (SMD), 4000K
These products contain a light source of energy efficiency class D
- Non-replaceable light source Non-replaceable control gear
- Conformity with all relevant UKCA Directive requirements.
- Conformity with all relevant EC Directive requirements.
- The power supply is Double Insulated and does not require connection to an Earth circuit
- Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or local store for recycling advice.
- This product is not suitable for dimming
- Caution! Risk of electric shock!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>