Newell LUNAR LED Lamp Instruction Manual

June 13, 2024
Newell

Newell LUNAR LED Lamp Instruction Manual
Newell LUNAR LED Lamp

SAFETY INSTRUCTIONS

The lamp is a precision device. Do not drop, hit, crush or expose to any shock. The unit is not dustproof or waterproof. Store in a dry, cool and ventilated place. Do not expose to water or other sources of moisture. Do not use near flammable materials and solvents. Do not use the lamp too close to objects. Do not cover the ventilation holes. Do not insert metal parts into the lamp. Do not touch the electrical parts with conductive materials. The lamp can operate in a temperature range of 0°C -40°C. The lamp will heat up slightly, but it is normal. Do not stare directly at the LED panel that is turned on, it may cause eye damage. Do not use the LED outside in direct sunlight for a long time. Disconnect the power supply for storage or transportation. Do not lift the camera while holding the lamp handle. Allow the unit to cool down before placing it in the package, For use by adults. If you notice smoke or a strange smell coming from the device, immediately disconnect the power. Do not disassemble. Disassembling the unit will void the warranty. If there are problems with the lamp, bring it to an authorized service center.

Important!
When the device shows low power, please recharge the lamp. When not in use for a long time, please recharge it every 3 months to ensure the durability of the battery. Please cover the rubber piece of USB ports well after recharging of discharging to avoid foreign matter.

Maintenance

Use a dry and soft cloth to clean the unit. Do not clean with water. A little neutral detergent on the cloth to remove stubborn dirt. Do not use strong detergents such as thinner, benzine or alcohol as they may damage the protective coatings.

SET CONTENT

  • Led LUNAR lamp-1 pc.
  • Tripod – 1 pc.
  • USB-C cable – 1 pc

CONSTRUCTION

Battery charge indicator
On/Off/Mode switch
Snap Hooh
Socket for bits
Multifunction spanner
Bottle opener
USB-C charging port
Window breaker 1/4 inch thread

USAGE

Light modes:
Single clicks: cold strong light-cold weak light-warm strong light-warm weak light-red continuous light-red flashing light.
Hold ON/OFF for three seconds – highest light output.
To switch off-single click

Product features:

Snap Hooh-the product comes with a carabiner so you can attach it to many items. Glass breaker-if you need to break a pane of glass, the glass breaker is an easy way to do this, thanks to the glass breaker at the top of the product Bottle opener – makes opening a bottle with a cap a breeze Multifunction spanner-if you need to tighten or loosen a socket screw Mini screwdriver – on the back of the product you will find four bits (two flat, two crosses), and under the on/off switch a bit slot. Pull the bit out of the holder and then insert it into the bit socket. Tripod socket – at the bottom of the product you will find a socket that makes it easy to insert a tripod Simple charging – on the side of the product you will find a USB Type-C port for charging 5.

CHARGING / DISCHARGING

Insert the USB Type-C cable into the socket on the side of the product and then connect to the charger. The light will adjust the charging current. It will take approximately 1h to fully charge the product.

There are four LEDs on the back of the product to indicate the level of charge

INSTALLATION

Snap hooh

Tripod
There is a 1/4 inch thread on the bottom of the light. Place the tripod thread into the socket of the light and then screw in the tripod. Spread the tripod legs and place on a flat surface.

You can also use the tripod as a handle to hold the light. Simply grasp the folded tripod legs in your hand.
Tripod

Power: 10W
Brightness: white light: 460Im , yellow light: 420Im , white +yellow light:

600Im
Battery capacity:| 500mAh
Material:| Aluminium alloy, plastic
Charging port| Typ-C
Charging time:| approximately 1h
Lighting time:| 2-3h
Weight:| 45g
Dimensions:| approx. 8 x 4.5 x 2.3cm
Light mode:| white strong light, white weak light, yellow stronglight, yellow weak light, red light, red flashinglight, long press: strong light

WASTE MANAGEMENT

The crossed-out trashcan symbol means that waste electrical and electronic equipment, batteries and packagings must not be placed with other household waste. They must be handed over to a separate waste collection system.

WARRANTY

Newell products are covered by a 40-month manufacturer’s warranty.

The manufacturer reserves the right to change the information contained in this manual without prior notice.

Made in China.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals