PNI S916 Pro GPS Navigation System Car User Manual

PNI S916 Pro
GPS navigation system + car DVR

User manual

Safety warnings

Do not power the device at a voltage other than that recommended by the manufacturer (5V 2A)
Do not expose the device to direct sunlight.
Do not use the device in areas with electromagnetic interference.
Do not mount the device in front of the airbags.

Product presentation

1. On/Off button
2. Mini USB port
3. TFT LCD touch screen
4. Micro SD card slot| 5. Reset button
6. Speaker
7. DVR Camera
---|---

Installation instructions

1. Suction cup
2. Locking lever| 3. Angle adjustment wheel
4. GPS bracket
---|---

Instructions for use

Turn the device on
To turn on the device, long press the power button until the screen lights up.

Standby
To put the device on standby, briefly press the on/off button. The screen turns off.

Turn the device off
To turn off the device, long press the on/off key until the control menu appears on the screen, then press the “Power Off” button.

Power supply
Connect the power cable to the mini USB port of the device and insert the cigarette lighter plug into the dedicated slot on the vehicle dashboard.

Operating instructions

How to solve GPS connection problems:

1. Before using the device inside the car, move it in the open air. Generally, outdoors, the device will connect to GPS satellites in about 3~5 minutes.
2. To reduce the connection time, after starting the navigation application, close the screen by briefly pressing the on/off button.

If you do not receive a GPS signal, check as follows:

1. Ensure you are not inside a building, in tunnels or under bridges.
2. In crowded cities with tall buildings, the GPS signal can be affected.
3. If you have tinted windows, they can affect the GPS signal.
   After setting the destination, if the application does not establish the route, the reason may be a GPS connection error. Ensure the device is connected to the GPS satellites, then set the route again.

Note!
Before the first use, charge the device for at least 5 minutes, to provide enough energy to start.
For the first use, move the device outside the vehicle and wait about 3~5 minutes to connect to the GPS satellites.

Reset
If an unknown error appears, press the reset button on the back of the device with a sharp object.
The device will return to factory settings.

Technical specifications

EU Simplified Declaration of Conformity
SC ONLINESHOP SRL declares that GPS navigation system + DVR PNI S916 Pro complies with the Directive RED 2014/53/UE. The full text of the EU declaration of conformity is available at the following Internet address: https://www.mypni.eu/products/9017/download/certifications

References

• mypni.eu/products/9017/download/certifications

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>