TRANSTYLE AI5000 BC04 OpenEar Go Bone Conduction Headphones User Guide

TRANSTYLE AI5000 BC04 OpenEar Go Bone Conduction Headphones

WHAT’S INCLUDED

A CLOSER LOOK

1. Neck Band
2. LED Indicator Light
3. Microphone
4.  Button (volume down/last track)
5. Multifunction Button
6. USB-C Charging Port

CHARGING

• Insert one end of the included USB-C charging cable into the charging port on your headphones.
• Insert the other end into the USB port of a computer or suitable USB charging adapter .
• Charging takes approximately 2 hours to complete.

POWERING ON/OFF

Press and hold the Multifunction Button for approximately 3-5 seconds to power on or power off your headphones.

BLUETOOTH PAIRING

• Once powered on, your headphones will go into pairing mode. The LED Indicator will alternately flash red and blue.

• Go to the Bluetooth settings menu on your phone. Make sure that Bluetooth is turned on. Connect to the device listed as
  “AIWA Open Ear Go.”

• Once paired, the LED Indicator will turn blue, flashing slowly.

LISTENING TO MUSIC

• Press the Multifunction Button once increase volume. Press and hold to go to the next track.
  • Double press to play or pause a track
• Press the• Button to decrease volume. Press and hold to go to the previous track.

HANDLING CALLS

• Double press the Multifunction Button to accept an incoming call or end a call.
  • Press and hold to reject an incoming an incoming call.
• Triple press the Multifunction Button to access your phone’s vocal assistant.

SAFETY PRECAUTIONS

When using your headphones, basic safety precautions should always be followed including:

1. READ ALL INSTRUCTIONS BEFORE USING YOUR HEADPHONES.
2. Do not submerge in water.
3. Only clean using a clean cloth.
4. Do not allow children to play with this product. This product contains small pieces that can be a choking hazard. Parental supervision is advised.
5. Do not expose this product to excessive heat or fire.
6. Do not expose this product to temperatures above 100°F. Keep out of direct sunlight.
7. Do not attempt to repair this product yourself. Contact a qualified service center if the product is in need of service.
8.  Do not drop, crush, or expose this product to excessive physical force.
9. This product is not intended for commercial use.
10. When charging, keep all charging cables well ventilated. Do not keep your charging cable in contact with flammable materials such as bedding, linens or synthetic fabrics.

Maintenance and Care

• Use a soft cloth or paper towel to clean your headphones. Never use any harsh chemicals or detergents for cleaning. Make sure your headphones are dry before charging.
• When your headphones are not in use, they should be stored in a cool, dry place.
• Never tug or yank on a cable while it is connected to your headphones. Connect and disconnect cables as carefully as possible.
• Never expose your headphones to high temperatures, extreme cold.
• Please recycle or dispose of your headphones properly based on the laws and rules of your municipality. Contact local recycling facilities and/or the manufactur­er of your headphones for further information.

FCC STATEMENT

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help.

SPECIFICATIONS

• Bluetooth Version: 5.0
• Weight: 30.5g
• Battery: 3.7V/230mAh Rechargeable Lithium Battery
• Charging Time: Approximately 2 Hours
• Play/Call Time: Approximately 6-8 hours*
• Transmittance Distance: 1 Om
• Waterproof Rating: IPXS

Applicable at 50% of maximum volume. Results will be lower when volume is higher.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>