DROP BMR1 Nearfield Monitors Speaker User Guide
- June 12, 2024
- DROP
Table of Contents
DROP BMR1 Nearfield Monitors Speaker
BMR1 Nearfield Monitors
Quick Start Guide
To ensure the proper installation and usage of your BMR1 Nearfield Monitors, please follow the instructions below:
Installation
-
Open the included accessory pack and locate the stand.
-
Attach the stand to the speaker according to your desired orientation:
- Vertical Orientation: Follow the instructions on Page 1 of the user manual.
- Horizontal Orientation: Follow the instructions on Page 2 of the user manual.
Connection
-
Locate the provided speaker cable.
-
Connect the passive speaker to the active speaker using the speaker cable.
Power Supply -
Locate the power supply.
-
Plug in the power supply into the active speaker first.
-
Connect the power supply to a 100~240 Vac power source.
Please refer to the complete user manual for detailed information and additional instructions.
Drop BMR1 Nearfield Monitors
Quick Start Guide
- Install stand to the speaker using included accessory pack.
- Connect the passive speaker to the active speaker using speaker cable provided.
- Plug in the power supply into the active speaker first, then connect the power supply to 100~240 Vac source.
- Connect to audio source and play:
- Analog in – Via 3.5 mm jack interconnect cable.
- Digital in – Bluetooth
- Button Function
- Default Mode – Analog In. Indicated by a solid white light, this is the first mode when the device is powered on.
- Bluetooth Mode – To enter this mode, single press from the default mode. When connecting for the first time, the device will automatically enter pairing. Pairing Mode is characterized by fast pulse blinking of the light. If connection is made, the light will turn to a solid blue. When idle and no active connection, the light will slow blink. To pair to a different device, holding the button for 3 seconds will activate Bluetooth Pairing Mode (must be in Bluetooth mode to do this).
- Headphone Mode – Mode will be skipped when no headphones are detected. When in this mode with headphone connected, the speaker output will be disabled until the mode is switch back to either default or Bluetooth. It is also possible to use a gaming headset with mic support when the BMR1 is connect with the supplied TRRS cable plugged into a compatible device such as a laptop.
- Master Reset – Long press for 12 seconds to activate master reset in any mode. The light will turn off for a short period and light up again signaling a successful reset.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>