ONE FOR ALL URC 7966 Smart Control Pro Remote User Manual

June 12, 2024
ONE FOR ALL

SMART CONTROL PRO

URC 7966 Smart Control Pro Remote

ONE FOR ALL URC 7966 Smart Control Pro Remote

WARRANTY

WARRANTY / GUARANTEE INFORMATION
Terms and Conditions for “100% Guaranteed To Work” policy, and the seperate 1 Year Limited Warranty against defects in material and workmanship can be found at www.oneforall.com/remoteguarantee, or you may request hard copies by calling 855-716-2573, or via mail to UEI Technical Support Service, Suite 301, 26250 Euclid Ave., Euclid, OH 44132. Please include your full name, product information, and contact information in your request communication.
LEGAL NOTICES
FCC STATEMENT:
FCC ID: MG3-117966
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
www.oneforall.com 
Customer Support: 855-716-2573 (toll free)
OFA warranty/terms & conditions:
855-569-6595 (toll free)
www.oneforall.com
Imported into the US by:
Universal Electronics Inc.
UEI Technical Support Services,
Suite 301 26250 Euclid Ave. Euclid,
OH 44132
One For All is a registered trademark of UEI,
Made in China, Hecho en China
RDN1200623

INDUSTRY CANADA REQUIREMENTS

ISED ID 2575A-117966.
This device complies with Industry Canada license‐exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device

CANADA RF EXPOSURE COMPLIANCE

To comply with RSS -102 requirements, a separation distance of 15 mm must be kept between the device and the user at all times.
CANADA RF EXPOSURE COMPLIANCE
This product complies with the FCC/IC RF Exposure for Low Power Consumer Wireless Power Transfer. The RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual.
The furthest RF exposure that compliance was demonstrated at 15mm and greater separation from the user body or set the device to lower output power if such function is available.
Problems pairing?
Scan the QR code below for help

A QR code that refers to the relevant APP
Virtual Agent
If you need help at any time during setup, please use the Virtual Agent in the app.
Connect with us

| facebook.com/oneforallworldwide
---|---
| @oneforall.worldwide
|  linkedin.com/company/one-for-all-worldwide/
| youtube.com/user/oneforallproducts

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

ONE FOR ALL User Manuals

Related Manuals