eta 0893 90000 LED Table Lamp User Manual
- June 12, 2024
- ETA
Table of Contents
eta 0893 90000 LED Table Lamp
Product Information
- Product Name: LED Table Lamp
- Model Number: eta 089390000
Product Usage Instructions
Safety Warnings
- The appliance must not be immersed in water or other liquids (not even partially)! If the appliance falls in water, do not take it from the water! First disconnect the power cord plug from the electrical socket, and then take out the appliance from the water. In such cases, bring the appliance to a specialized service center to verify its safety and proper operability.
- The appliance is intended for home use and for similar purposes (in shops, offices and similar sites, in hotels, motels and other residential premises, or in facilities providing bed and breakfast service). It is not intended for commercial use!
Device Layout
- A – LED panel
Operating Instructions
| Setting | Instructions |
|---|---|
| Basic setup | N/A |
| Time and date settings | N/A |
| Alarm settings |
-
Press M button. The appliance will switch to the alarm setting
mode. -
Alarm mode is indicated by the icon in the upper left corner of
the display. -
In this mode, the alarm time can be set by pressing S button
and changing the time using “+” and “-” buttons. -
After setting the time, you may choose a snooze time ZZ (from 1
to 60 minutes). -
Press S button again to switch to the buzzer tone selection (8
different melodies and tones). -
Press S button again to exit the alarm setting mode.
Temperature indicator setup| Press the button
Time display setup| Use the button to change the time display mode to 12/24
format.
Maintenance
Do not use coarse and aggressive cleaning agents (e.g. sharp objects,
scrapers, diluting agents or other solvents). Clean with a soft and wet cloth
with a little detergent.
Environmental Protection
Follow the manufacturer’s instructions for disposal. Failure to comply with
the instructions of the manufacturer will lead to expiration of the right to
warranty repair!
Technical Data
- Input in off mode is < 0.50 W
- The manufacturer reserves the right to change the technical specifications and accessories for the respective models.
Warnings and Symbols
- HOUSEHOLD USE ONLY; DO NOT IMMERSE IN WATER OR OTHER LIQUIDS;
- TO AVOID DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS, CARRIAGES OR PLAYPENS. THIS BAG IS NOT A TOY.
Table LED lamp
eta 08939000
INSTRUCTIONS FOR USE
Dear customer, thank you for purchasing our product. Please read the operating
instructions carefully before putting the appliance into operation and keep
these instructions including the warranty, the receipt and, if possible, the
box with the internal packing.
SAFETY WARNINGS
-
Consider the instructions for use as a part of the appliance and pass them on to any other user of the appliance.
-
Check whether the data on the type label corresponds with the voltage in your socket. The power cord plug may only be connected to the electrical socket complying with the applicable standards.
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. Children younger than 8 years must
be kept out of reach of the appliance and its charger. -
Before replacing accessories or accessible parts, before assembly and disassembly, before cleaning or maintenance, turn off the appliance and disconnect it from the mains by pulling the charger from the power socket!
-
If the power cord of the charger is corrupted, it has to be replaced by the manufacturer, its service technician or a similarly qualified person so as to prevent dangerous situations.
-
Never use the appliance if its charging adapter is damaged, if it does not work properly, if it fell down and was damaged and it is leaking. In this case take the appliance to a special service to check its safety and proper function.
-
The appliance must not be immersed in water or other liquids (not even partially)! If the appliance falls in water, do not take it from the water! First disconnect the power cord plug from the electrical socket, and then take out the appliance from the water. In such cases, bring the appliance to a specialized service center to verify its safety and proper operability.
-
The appliance is intended for home use and for similar purposes (in shops, offices and similar sites, in hotels, motels and other residential premises, or in facilities providing bed and breakfast service). It is not intended for commercial use!
-
The adaptor supplied with this appliance is intended for this appliance only, do not use it for other purposes. Also, use only the supplied adaptor with this appliance, do not use any other adaptor for charging (e.g. from another appliance).
-
Never immerse the appliance, the charging dock or the adaptor in water or other liquids (not even partly) and never wash in running water!
-
When adjusting the lamp neck, hold the lamp base and make sure that when adjusted, the lamp is sufficiently stable.
-
Protect eyesight of people and animals from direct light from the LEDs.
-
When adjusting the lamp neck, make sure not to damage the lamp (its joint) – do not apply excessive force.
-
The lamp may switch on/off in case of strong electromagnetic interference.
-
Do not bend the LED panel and protect it from any impact to prevent its damage.
-
Do not use the appliance in bathrooms, near showers and in places with high humidity.
-
LEDs cannot be replaced.
-
When the lamp is on, the LEDs become warm – do not touch them.
-
If the lamp is not to be used for a long time, unplug the adapter from el. power.
-
This appliance is not intended for outdoor use.
-
Do not put or take out the plug to or from a socket with wet hands!
-
The appliance must not be used in a damp or wet environment and in any environment with the danger of fire or explosion (premises where chemicals, fuels, oils, gases, paints and other flammable or volatile materials are stored).
-
Only use the appliance in the working position at places with no risk of overturning and
in a sufficient distance from other objects (such as curtains, drapes, etc.), heat sources (e.g. fireplace, heater, stove, cooker, radiators, hot air ovens, grills) and wet surfaces (e. g. sinks, wash basins). -
Never put the power cord on hot surfaces and never let it hang over table edge or worktop edge. If the cord is caught or pulled,
e. g. by children, the appliance may overturn and fall down, causing a serious injury! -
The manufacturer assumes no responsibility for any damage caused by improper handling of the appliance and its accessories (e.g. electric shock, fire), and the appliance guarantee
will become void if any of the aforementioned safety instructions are not observed.
DEVICE LAYOUT
LED lamp
- A – LED panel
- B – Current time, date, weekday and indoor temperature indicator
- C – Light button
- D – Time and date setup control
- E – Compartment for battery to feed the display
- F – Power supply connector input
OPERATING INSTRUCTIONS
Basic setup
Connect the power supply adapter connector to F power supply input. Connect
the power supply adapter to the mains.
Open the battery compartment E using a screwdriver and insert a CR 2032
battery. After inserting the battery, close the cover with the screwdriver.
Light up the lamp with C button. When switched on, the lamp light will be at
the lowest brightness level. Repressing the button, you may change the
brightness to medium level and then to the highest level. Switch the lamp off
by pressing the button one more time.
Time and date settings
The current time and date may be set using D buttons on the back of the lamp.
The buttons are marked as follows:
- S – SET,
- M – MODE,
- ˄ – UP,
- ˅ – DOWN
Press S button. Hour indicator will start flashing. Set the desired value
using ˄ and ˅ buttons. Press S button repeatedly to set minutes – year – month
– day, and to cancel the setup mode.
Note: If you do not press any button for 1 minute in setup mode, the
appliance will switch to normal mode.
Alarm settings
Press M button. The appliance will switch to the alarm setting mode.
Alarm mode is indicated by icon in the upper left corner of the display. In
this mode, the alarm time can be set by pressing S button and changing the
time using ˄ and ˅ buttons.
After setting the time, you may choose a snooze time ZZ (from 1 to 60
minutes).
Press S button again to switch to the buzzer tone selection (8 different
melodies and tones). Press S button again to exit the alarm setting mode.
By pressing the ˄ and ˅ buttons in alarm mode, you may:
Activate the alarm – ♫ is displayed
Activate the alarm with the snooze function – ♫ and ZZ is displayed.
Deactivate the alarm – neither ♫ nor ♫ + ZZ is displayed.
Press M button to switch the display to time display mode.
If the alarm is active, the tone sounds for 1 minute. It can be interrupted by
pressing any button on the back of the lamp.
Temperature indicator setup
Indoor temperature display in °C or °F may be changed using ˅ button.
Time display setup
Use ˄ button to change the time display mode to 12/24 format.
MAINTENANCE
Do not use coarse and aggressive cleaning agents (e.g. sharp objects, scrapers, diluting agents or other solvents). Clean with a soft and wet cloth with a little detergent.
ENVIRONMENTAL PROTECTION
If the dimensions allow, there are labels of materials used for production of
packing, components and accessories as well as their recycling on all parts.
The symbols specified on the product
or in the accompanying documentation mean that the used electric or electronic
products must not be disposed of together with municipal waste. For proper
disposal of the product, hand it over at special collection places where it
will be taken over free of charge. Suitable disposal of the product can help
to maintain valuable natural resources and to prevent possible negative
impacts on
the environment and human health, which could be the possible consequences of
improper waste disposal. Ask for more details at the local authorities or in
the nearest collection site. Fines can be imposed for improper disposal of
this type of waste in agreement with the national regulations. If the
appliance is to be put out of operation for good, after disconnecting it from
power supply we recommend cutting off the power cord and thus it will not be
possible to use the appliance again.
More extensive maintenance or maintenance requiring intervention in the inner
parts of the appliance must be carried out by professional service! Failure to
comply with the instructions of the manufacturer will lead to expiration of
the right to warranty repair!
TECHNICAL DATA
- Brightness adjustment
- Flexi-neck
- Luminous flux: 450Lm
- Colour temperature: 5000K
- Illumination angle: 120°
- Life: up to 15,000 hours
- Energy rating: F
- Material: ABS
- Voltage: AC 180-240V 50/60HZ; output: 13V/ 0.46A
- Dimensions: 68 x 310 x 250 mm
- Weight: 448g
- Input: 6W
- Degree of protection: IP 20
- LCD display with time, date and alarm clock
- Separate display power supply: 3V CR2032
- Input in off mode is < 0,50 W
The manufacturer reserves the right to change the technical specifications and accessories for the respective models.
WARNINGS AND SYMBOLS USED ON THE APPLIANCE, PACKAGING OR IN THE INSTRUCTIONS MANUAL:
HOUSEHOLD USE ONLY; DO NOT IMMERSE IN WATER OR OTHER LIQUIDS;
TO AVOID DANGER OF SUFFOCATION, KEEP THIS PLASTIC BAG AWAY FROM BABIES AND CHILDREN. DO NOT USE THIS BAG IN CRIBS, BEDS,CARRIAGES OR PLAYPENS. THIS BAG IS NOT A TOY.
The symbol indicates a WARNING.
|
---|---
Charging adapter
A| Manufacturer’s name or trademark, business registration number and
address| DongGuan Toye Electronics Technology Co., Ltd
B| Model identifier| TY6W1300046E
C| Input voltage| 180-240 V (AC)
D| Input frequency| 50/60 Hz
E| Output voltage| 13.0 V (DC)
F| Output current| 0.46 A
G| Output power| 5.98 W
H| Average efficiency in
active mode
| 79.64 %
I| Low load efficiency (10%)| 10.48 %
J| Power consumption
without load
| 0.08 W