POLAR UA005 Counter Refrigerator Instruction Manual

POLAR UA005 Counter Refrigerator

Safety Instructions

• Position on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required.
• Consult Local and National Standards to comply with the following:
  • Health and Safety at Work Legislation
  • BS EN Codes of Practice
  • Fire Precautions
  • IEE Wiring Regulations
  • Building Regulations
• DO NOT use jet/pressure washers to clean the appliance.
• DO NOT use the appliance outside.
• DO NOT use this appliance to store medical supplies.
• DO NOT allow oil or fat to come into contact with the plastic components or door seal. Clean immediately if contact occurs.
• DO NOT store products on top of the appliance.
• Bottles that contain a high percentage of alcohol must be sealed and placed vertically in the refrigerator.
• Always carry, store and handle the appliance in a vertical position and move by holding the base of the appliance.
• Always switch off and disconnect the power supply to the appliance when not in use.
• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
• If the power cord is damaged, it must be replaced by a POLAR agent or a recommended qualified technician in order to avoid a hazard.
• Children should be supervised to ensure that they do not play with the appliance.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
• Polar recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.
• POLAR recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).

Warning: Risk of Fire / flammable materials

• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
• Warning: Keep all ventilation openings clear of obstruction. Unit should not be boxed in without adequate ventilation.
• Warning: Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
• Warning: Do not damage the refrigerant circuit.
• Warning: Do not use electrical appliances inside the food storage compartments of the appliance, unless they are the type recommended by the manufacturer.

Product Description

• UA005 – Polar 2 door Counter Refrigerator
• UA006 – Polar 2 door Counter Freezer
• UA007 – Polar 3 door Counter Refrigerator
• UA008 – Polar 3 door Counter Freezer

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your POLAR product.

Pack Contents

The following is included:

• POLAR Refrigerator / Freezer
• Keys
• Shelves
• Shelf support bars
• Instruction Manual

POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your POLAR dealer immediately.

Installation

Note: If the appliance has been stored or moved in a non-vertical position, stand it in an upright position for approximately 12 hours before operation. If in doubt allow to stand.

1. Remove the appliance from the packaging and remove the protective film from all surfaces.

2. To optimize performance and longevity, ensure a minimum clearance of 2.5cm is maintained between the unit and walls and other objects, with a minimum 5cm clearance on the top. NEVER LOCATE NEXT TO A HEAT SOURCE.
   Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.

3. Set the brakes on the castors to keep the appliance in position.

Fitting the shelf support bars

• Place the support bar on the ladder at the desired height. For installation, the closed end shall be located at rear and open end at front.

1. Push the support bar backwards to let its rear end hang on the rear ladder (Step 1).
2. Lift the front end slightly then buckle it onto the front ladder (Step 2).

• Repeat for the remaining support bars.
• Slide the GN pans/shelves into place.

Operation

Control Panel for refrigerators (UA005/UA007)

Control Panel for Freezers (UA006/UA008) Turn On

1. Close the door/doors of the appliance.
2. Connect the appliance to the mains power supply.
3. To switch system on or off, press and hold for 3 seconds.

Adjusting the Temperature

1. Press for 3 seconds. The set temperature on the display will flash.
2. Press or to change the set temperature.
3. Wait 6 seconds for the set temperature to be stored.

Manual Defrost

Automatic defrost: The appliance features an automatic defrost. However, should the appliance require an additional defrost period, carry out below operations:

1. Press for 3 seconds to enter defrosting mode. The symbol will appear on the display.
2. Press for 3 seconds again to exit.

Short-cut operations for refrigerators only:

1. Press once to enter fish mode and display the set temperature (Range: -1°C ~ 1°C).
2. Press once to enter meat mode and display the set temperature (Range: -2°C ~ 2°C).
3. Press once to return to general mode and display the set temperature (Range: 1°C ~ 4°C).

Cleaning, Care & Maintenance

Warning: Switch off and disconnect from the power supply before cleaning the condenser.

• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Clean the door seals with warm soapy water.
• Always wipe dry after cleaning.
  Note: Condensation will form in refrigeration on hot humid days, please ensure condensation is allowed to drain properly or is wiped dry.

Cleaning the condenser (annually)

• The refrigerator is fitted with a self cleaning condenser that reduces the need for maintenance. However, annual checks are advised.
• The condenser is part of the refrigeration system. The condenser requires annual cleaning.
• When to clean the condenser, please Call POLAR agent or qualified Technician.
• Aways disconnect power supply before carrying out routine maintenance.
• Failure to clean the condenser will reduce the performance and life of your unit and may invalidate your warranty.

Cleaning the filter (monthly)

1. These models have a removable filter which can be taken out for cleaning.
2. Open the left hand door.
3. The filter tab will be visible behind the lower hinge. Pull this tab to remove the filter.
4. Clean the filter with a vacuum cleaner.
5. Replace the filter and close the door.

Troubleshooting

If the machine malfunctions due to causes other than those listed or the proposed corrective actions do not solve the problem please call a Polar agent or qualified technician.

plugged in correctly and switched on
Plug or lead is damaged| Call POLAR agent or qualified Technician
Fuse in the plug has blown| Replace the fuse
Power supply| Check power supply
The appliance is not cooling| Coolant Leak| Call POLAR agent or qualified technician
Fan Motor Failed| Call POLAR agent or qualified technician
Airflow to the condenser obstructed| Increase the gap between appliance and obstacles/heat source
Condenser is clogged| à Cleaning the condenser
Loud noises| Appliance is not level| Adjust position to make it level
Appliance is too close to a wall or other object| Move to a more suitable location
Odour from the unit| Unit is not cleaned for long time| Clean the unit thoroughly
Odour food not properly packed| Seal and pack odour food properly
Error code/ indication| Probable Cause| Solution
---|---|---
“ER1” and alarm| The evaporator inlet probe is faulty| Press any button to cease alarm. Call POLAR agent or qualified Technician to replace the faulty probe
“ER2” and alarm| The evaporator return gas probe is faulty| Press any button to cease alarm. Call POLAR agent or qualified Technician to replace the faulty probe
“ER3” and alarm| The defrost probe (evaporator temperature probe) is faulty| Press any button to cease alarm. Call POLAR agent or qualified Technician to replace the faulty probe
“ER4” and alarm| Door not closed properly or door switch is faulty| Press any button to cease alarm. Close the door/doors properly or check the door switch
“ER5” and alarm| Condenser probe is faulty| Press any button to cease alarm. Call POLAR agent or qualified Technician to replace the faulty probe
“SO” and alarm| Cabinet temperature probe is open-circuited| Press any button to cease alarm. Call POLAR agent or qualified Technician to replace the faulty probe
“SC” and alarm| Cabinet temperature probe is short-circuited| Press any button to cease alarm. Call POLAR agent or qualified Technician to replace the faulty probe
“HI” and alarm| Condenser temperature exceeding 60°C| Power off and re-start machine to cease alarm. Press power button  for 1 second to check the condenser temperature on the screen. Clean the condenser filter immediately, or Call POLAR agent or qualified technician

Technical Specifications

Model| Voltage| Power (W)| Temp. Range| Refrigerant| Dimensions H x W x D mm| Weight (kg)
---|---|---|---|---|---|---
UA005| 220-240V~ 50Hz| 350| -2°C ~ +4°C| R290| 850 x 1420 x 660| 94.20
UA006| 220-240V~ 50Hz| 605| -18°C ~ -22°C| R290| 850 x 1420 x 660| 99.00
UA007| 220-240V~ 50Hz| 465| -2°C ~ +4°C| R290| 850 x 1885 x 660| 117.00
UA008| 220-240V~ 50Hz| 670| -18°C ~ -22°C| R290| 850 x 1885 x 660| 123.80

Electrical Wiring

POLAR appliances are supplied with a 3 pin BS1363 plug and lead. The plug is to be connected to a suitable mains socket. POLAR appliances are wired as follows:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E

This appliance must be earthed. If in doubt consult a qualified electrician. Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Disposal

EU regulations require refrigeration products to be disposed of by specialist companies who remove or recycle all gasses, metal and plastic components. Consult your local waste collection authority regarding the disposal of your appliance. Local authorities are not obliged to dispose of commercial refrigeration equipment but may be able to offer advice on how to dispose of the equipment locally. Alternatively, call the POLAR helpline for details of national disposal companies within the EU.

Compliance

The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area. POLAR parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities. POLAR products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of POLAR. Every effort is made to ensure all details are correct at the time of going to press, however, POLAR reserve the right to change specifications without notice.

References

• Polar Refrigeration - Commercial Refrigeration

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>