Berker KNX-RF Hand Held Transmitter 6 and 18 Channels Instruction Manual

: June 4, 2024
: Berker

Table of Contents

Berker KNX-RF Hand Held Transmitter 6 and 18 Channels
User instructions
Configuration
Cloning of transmitters
Technical characteristics
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Berker KNX-RF Hand Held Transmitter 6 and 18 Channels

User instructions

The devices are used for the remote control of KNX-RF receivers. They make it possible to remotely control lighting, blinds or rolling shutters, heating…

Functions

6 or 18 send buttons that can be configured independently 2
LED for sending confirmation 1
Labelling field 4
Automatic switch-on of keys and label holder lighting is provided when taking control for 4 seconds (18 channel version only).

Configuration

These transmitters may be configured in 3 different ways :

quick links: configuration without tool, directly on the device via R button and LED (see configuration instructions quicklinkL).
tebis TX: configuration using connection device from Hager
ETS3/ETS4 via KNX-RF/TP gateway: database and description of software application available from the Manufacturer.

Configuration by ETS
Press R button for addressing by means of radio/KNX Gateway.

In order to change the configuration mode, a reset to factory settings is required.

Cloning of transmitters

Cloning allows duplicating a “Master” radio transmitter previously configured to create fully identical copies quickly.

Confirmation LED 1

– Batteries are not placed correctly

How to clone a transmitter?

Enter in configuration mode by pressing the R button of the “Master”: LED cfg turns on.
On the product to be cloned still in factory mode, press R button for an extended time >15 s until the 2nd flickering level (faster) of LED cfg is reached. When LED flickering ends (LED turns off), cloning is completed.
Repeat this step for the other products to be cloned.
Exit the cloning mode by pressing again Master R button. When button is pressed, LED cfg turns orange to signal the cloned transmitter.
- Cloning is possible only between transmitters with the same number of inputs. A cloned product cannot be modified, including the “Master”. A reset to factory settings and a new programming of the devices are required.

Activation/deactivation of indicators and of labelling field (18 channel version only)

For activating/deactivating lighting of indicators 3 and label holder 4, move selector 5 to a new position and press shortly key 2 located under indicator

Selector 5 (18 channel version only) KNX-RF hand-held transmitter 18 channels can transmit 18 different controls distributed over 3 groups of 6 keys. Selector 5 is used to select one of the three groups.

Reset to factory settings
Hold the R button depressed until cfg LED flickers 10 s, then release it. LED cfg turns off to signal the end of factory reset. This operation removes the entire product configuration, whatever the mode of configuration. After power- on or reset to factory settings, wait 15 s before proceeding to configuration.

Replacement of batteries
Dismantle battery compartment lid 6. Remove the 2 batteries and insert the new ones making sure that matching of poles (+/-) is correct (both batteries must be changed). Place battery cover 6 back on.Usable in all Europe and in Switzerland Hereby, Berker GmbH & Co. KG, declares that this radio frequency remote control is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The CE declaration can be consulted on the site: www.hagergroup.com