EUROfase 35698-012 Nelson Chrome Bath Bar Instruction Manual
- June 12, 2024
- EUROfase
Table of Contents
EUROfase 35698-012 Nelson Chrome Bath Ba
Product Information
You have purchased a lighting product that is designed and built to provide
you with years of enjoyment. The product specifications are as follows
- Model Number: 35698
- Power: 32W MAX
- Voltage: 120V
- Frequency: 60Hz
- LED Type: Dimmable LED (included)
Product Usage Instructions
- Estimated Assembly Time: 20 minutes
- Tools Required For Assembly (not included):
- Flathead screwdriver
- Phillips screwdriver
- Pliers
- Electrical tape
- Wire cutters
- Helpful Tools (not included):
- Wire strippers
- Ladder
- Follow the steps below for assembly:
- Secure the product to an outlet box using the provided outlet box screws (A).
- Connect the black wire (L) from the junction box (B) to the black wire (L) from the fixture (E) using a wire connector (H).
- Connect the white wire (N) from the junction box (C) to the white wire (N) from the fixture (F) using a wire connector (H).
- Connect the green wire/bare copper (G) from the junction box (D) to the green wire/bare copper from the fixture (G) using a wire connector (H).
- Repeat steps b, c, and d for any additional wires.
Make sure to consult these instructions for any future reference.
Thank You
You’ve just purchased a lighting product designed and built to provide you
with years of enjoyment.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
- Follow the assembly instructions by reading the numerical progression.
- Use a qualified electrician for the installation of this lighting fixture.
- Before installing the fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
- All electrical connections must be in accordance with local and National Electrical Code or Canadian Electrical Code standards.
- Use CSA or UL-listed wire connectors suitable for the gauge, type, and number of conductors.
- Attach the junction box grounding wire (green or bare copper) and the bare copper wire from the fixture together.
- If the junction box has no ground wire, attach the bare copper fixture wire to the green ground screw on the crossbar.
Estimated Assembly Time: 20 minutes
Tools Required For Assembly (not included): Flathead screwdriver, Phillips screwdriver, Pliers, Electrical tape, and Wire cutters.
Helpful Tools (not included): Wire strippers, Ladder
32W MAX LED 120V 60Hz
(Dimmable LED included)
- Outlet Box screw x 2
- Black wire(L) from junction box
- white wire(N) from junction box
- Green wire/Bare copper (G) from the junction box
- Black wire (L) from a fixture
- White wire (N) from fixture
- Green wire/Bare copper from the fixture
- Wire connector x 3
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>