SHARKWARD ANT-5-X-BLE Bluetooth Microwave Fixture Sensor User Manual
- June 12, 2024
- Sharkward
Table of Contents
SHARKWARD ANT-5-X-BLE Bluetooth Microwave Fixture Sensor
SPECIFICATION
The ANT-5-4T-BLE uses microwave motion detector architecture technology for improved detection coverage for high bay applications.
OVERVIEW
- Microwave sensor.
- Bluetooth® SIG mesh.
- High-End Trim, Zoning, Continuous Bi-level Dimming.
- LED Motion indicator.
- Mounting height up to 40 ft .
- 360° coverage pattern.
- Low Voltage connector.
- Technology Partner SIL VAIR.
FEATURES AND BENEFITS
- Bluetooth to 0-1 0V signal converter, Bluetooth® mesh network.
- Built-in 20mA 0-1 0V signal output.
- Mesh network, which has a much longer control distance, transmits received signals to neighboring devices.
- All devices on 0-1 0V line are broadcast controlled by mobile application.
- In typical outdoor environment, the typical range for wireless communication is 200ft(60m).
- Actual range is dependent on field installation.
- Available with Magnetic reset (Touch the top part of sensor for 5 seconds).
- On-board antenna.
TECHNICAL DATA
SENSOR COVERAGE
ORDERING INFORMATION
- ANT-5-4T-BLE
- Bluetooth Microwave Fixture Sensor
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including Interference that may cause undesired operation.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Caution: The user is cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>