Double E E6640-003 RC Detachable Flatbed Tractor Semi Trailer Combo Excavator Truck User Manual

Double E E6640-003 RC Detachable Flatbed Tractor Semi Trailer Combo

Excavator Truck

Introduction

• Item No.: E6640-003
• Materials: plastic and electronic components
• Vehicle battery: 3.7V AA rechargeable battery
• Remote control battery: 2 pcs of 1.5V AA batteries (not included)

Installing batteries

1. Remove the battery compartment door at the back of the remote control (Picture2A). Install 2 pcs of 1.5V AA batteries in the correct polarity as indicated into the battery compartment. Reinstall the battery door and fix it with the screw (Picture 2A).
2. Remove the battery compartment door at the back of the vehicle. Install 1 pc of 3.7V AA rechargeable battery in the correct polarity as indicated into the battery compartment. Reinstall the battery door and fix it with the screw (Picture 2B).

2.4GHz pairing procedure

1. Install the batteries into the vehicle and the remote control. Turn on the remote control and the vehicle. The pairing procedure will start automatically. The remote control indicator light will turn off and the vehicle will emit a double beep indicating that the pairing procedure was successful. (Picture 4A)
2. The remote control can be paired only with one vehicle at a time. Each set has an interference-free system.
3. If there is no linking signal for 1 minute the remote control will automatically shut down.
4. To re-pair the set restart the remote control and the vehicle.

Operations

1. Forward / Reverse
   Push left stick (throttle) forward/backward and the vehicle will go forward/backward (Picture 4B).

2. Turn Left / Right
   Push right stick left/right and the vehicle will turn left/right (Picture 4C).

3. Horn button
   Press the Horn/Mute button and the vehicle will emit simulated horn sound.

4. Speed Switch
   Use beginner/high speed mode buttons to adjust the speed mode accordingly. (Picture 4D)

Recharging

Notice:
Always turn off the set and remove the batteries when the vehicle is not in use and when it is being stored. The vehicle battery charging time is about 3 hours. Do not charge more than 8 hours.

Notice

1. Do not drive on roads or areas used by real vehicles. Choose safe operating areas.
2. Do not drive in rain, snow, wetness or sand. Use dry cloth to clean the vehicle.
3. If the speed slows down or the vehicle does not properly turn right or left, please re-charge the battery.
4. The batteries should be charged under direct supervision of and adult. Please use only recommended batteries.
5. Pay attention to the battery polarity.
6. Avoid using old and new batteries together.
7. Please, charge the battery before initial use.
8. Regularly inspect the cable, plug, casing and other parts for damages. Do not use damaged batteries or charging lines.
9. Connect the battery only with the regular 5V USB chargers.

CHOKING HAZARD
Small parts, not for children under 3 years. Specifications, colors and contents may vary from illustration. Hereby, [DOUBLEEAGLE INDUSTRY (CHINA)LIMITED], declares that this [REMOTE CONTROL CAR SERIES] is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. The full test of the EU declaration of conformity is available at the following internet address: www.doublele- group.com.

• Manufacturer: Doubleeagle Industry(China) Limited.
• Address: Xingda Industrial Park, Chenghai District, Shantou City, Guangdong Province, China.
• Importer: JAMARA e.K.
• Address: Inh.Manu el Natterer Am Lauerbuhl5-DE-88317 Aichstetten Germany

CHOKING HAZARD-small parts, not for children under 3 years.

FCC STATEMENT

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC SDoC

Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information

Unique Identifier

• Trade Name: Double E
• Model No.: E664-003
• Responsible Party – U.S. Contact Information

US Company Name:
Address: Xingda Industrial Park, Chenghai District, Shantou City, Guangdong Province, China.
Telephone number or internet contact information: 13715869498.

MODIFICATION:
Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>