ARCORA AR62115A3G Single Handle Centerset Bathroom Faucets Instruction Manual
- June 12, 2024
- ARCORA
Table of Contents
ARCORA AR62115A3G Single Handle Centerset Bathroom Faucets Instruction
Manual
You may need
For easy installation of your faucet you will need:
To READ ALL the instructions completely before beginning.
To READ ALL warnings, care, and maintenance information.
Cleaning and Care
Care should be given to the cleaning of this product. Although its finish is
extremely durable,
It can be damaged by harsh abrasives or polish. To clean, simply wipe gently
with a damp cloth and blot dry with a soft towel.
With 1.2 gpm are compliant with California water efficiency regulations, Complies with California Proposition 65 and with the Federal Safe Drinking Water Act.
In areas with extremely low water pressure causing the basin faucet water flow to be unsatisfactory , replace the 2.2 gpm aerator to improve the water flow in the basin faucet.
washer
1.2gpm aerator
aerator house
Dimensions
unit: inch (mm)
Pre drilled hole size: 1.26″ to 1.5″(32mm to 38mm) Hole Siz
Unsuitable sink size: 1″ to 1.2″(25mm to 30mm) Hole Size
Assembly Instruction
Notes
Before installing the valves, clean the water pipe thoroughly to avoid dirt
and deposits.
Attach mounting stud under faucet body
Attach flexible hoses under the faucet body.
-
Make sure attach the O-ring(1) to the base of faucet body.
-
Slide 6“decorated plate with gasket(2) up over tubes and mounting stud. Slide tubes down through mounting hole andfaucet, 6“decorated plate with gasket (2) on sink. Option: If sink is uneven, use silicone under the gasket.
-
Place washer(3) and metal plate(4) over mounting stud under sink. Secure with mounting nut(5)
-
Make sure attach the O-ring(1) to the faucet body.
-
Slide tubes down through mounting hole on sink.
Option: If sink is uneven, use silicone under the faucet body. -
Place washer(2) and metal plate(3) over mounting stud under sink. Secure with mounting nut(4).
-
Remove the washer (2) , black gasket (4) and nut (5) from the assembly.
-
Slide washer (2) up to underside of flange (3). Insert flange (3) and washer (2) into sink and secure with the black gasket (4) washer and nut (5) from underneath the sink.
-
Put down and check the pringloaded stopper (1).
-
Connect assembly to drain.
Secure metal nut on faucet supply hoses to supply valve connection and hand
tighten, then tighten one additional revolution with wrench.
DO NOT OVERTIGHTEN.
Repeat for other hose connection making sure the hose with the hot label is
connected to the hot supply valve and the other hose is connected to the cold
supply valve.
WARNING: Do not use pipe dope or other sealants on water connections
FLUSH SYSTEM/CHECK FOR LEAKS.
Turn on hot and cold water supplies and flush water lines for one minute.
Check all connections at arrows for leaks.
Re tighten if necessary, but do not over tighten.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>