ARCORA AR6100500GB Two Handle Lavatory Centerset Faucets Instruction Manual
- June 12, 2024
- ARCORA
Table of Contents
TWO HANDLE LAVATORY
CENTERSET FAUCETS
1.2GPM 4.5L/min
Instruction Manual
AR6100500GB Two Handle Lavatory Centerset Faucets
You may need For easy installation of your
faucet you will need:
To READ ALL the instructions completely before beginning.
To READ ALL warnings, care, and maintenance information.
With 1.2 gpm are compliant with
California water effi ciency regulations, Complies with California Proposition
65 and with the Federal Safe Drinking Water Act.In areas with extremely low water pressure causing the
basin faucet water flow to be unsatisfactory, replace the 2.2 gpm aerator to
improve the water flow in the basin faucet.
Cleaning and Care
Care should be given to the cleaning of this product. Although its finish is
extremely durable.
It can be damaged by harsh abrasives or polish. To clean, simply wipe gently
with a damp cloth and blot dry with a soft towel.
OPERATION
- Double levers style handles
- Maximum handle(s) rotation angle is 90˚ to full on
- Rotate hot side counter clockwise to open (clockwise to close)
- Rotate cold side clockwise to open (counter clockwise to close)
Notes
Before installing the valves, clean the water pipe thoroughly to avoid dirt
and deposits. Install
spout (1) O-ring (2), Secure with washer and nut (3).
Note: If sink is uneven, use silicone under the gasket. Attach flexible
hoses under the hot and cold end valves.
- Make sure attach the gasket to the base of hot (1) and cold (2) end valves.
- Slide hot (1) and cold (2) end valves with flexible hoses (3) through sink.
- Place washer(4) and metal plate(5) over mountingstud under sink. Secure with mounting nut(6).
- Lock mounting nut(6) into position by tightening screw (7).
NOT WITH apply teflon tape
to the quick connect installation.
Align tabs and tabs on quick connects .
Push quick connects firmly upward and snap onto receiving tube tab.
Pull down moderately to ensure each connection has been made.
-
Remove the washer (2) , black gasket (4) and nut (5) from the assembly.
-
Slide washer (2) up to underside of flange (3).
Insert flange (3) and washer (2) into sink and secure with the black gasket (4) washer and nut (5) from underneath the sink. -
Put down and check the Springloaded stopper (1).
-
Connect assembly to drain.
To flush debris from the plumbing system:
- Remove the aerator by hand.
- Run hot and cold water for one minute.
- Replace the aerator.
Repeat
for other hose connection making sure the hose with the hot label is connected
to the hot supply valve and the other hose is connected to the cold supply
valve.
FLUSH SYSTEM/CHECK FOR LEAKS.
Turn on hot and cold water supplies and flush water lines for one minute.
Check all connections at arrows for leaks.
Retighten if necessary, but do not overtighten.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>