ARCORA AR7104300C-43 Wall Mount Commercial Kitchen Faucet Instruction Manual

AR7104300C-43 Wall Mount Commercial Kitchen Faucet
Instruction Manual

Attach supply lines (not included).

8 inches adjustable center hole distance Wall mounted faucet using a pair of G1/2″ female inlets with 2″flanges.
those inlets can adjust from 7 3/4″(197mm) to 8 1/4″(209.5), allowing you to fit them directly onto your facility’s water lines with ease.
With 1.8 gpm are compliant with California water effi ciency regulations,Complies \with California Proposition 65 and with the Federal Safe Drinking Water Act.![ARCORA AR7104300C 43 Wall Mount Commercial Kitchen Faucet

• Fig 1](https://manuals.plus/wp-content/uploads/2023/07/ARCORA-AR7104300C-43 -Wall-Mount-Commercial-Kitchen-Faucet-Fig-1.png)

  1. Connect the two flanges (3) into the two inlets (5) . Screw them tightly.

  2. Connect the body (1) to the flanges (3), do remember the gaskets (2) inside.
     The two flanges (3) are adjustable inlets.
     Unscrew the hexagon nut (4) on the flange (3) , rotate the flange(3) to the right the distance and screw the hexagon thread back tightly.
     You can adjust the distance from 7 3/4″to8 1/4″.

  3. Turn out the hexagon (6), Use the hexagon nut to lock the faucet and sink.

  4. Insert the short riser (2) to the body (1) , Screw the thread (3) tightly. Connect the other side of the shorter riser (2) with the add-on faucet (5), Screw the thread (4) tightly.

  5. Put the swing nozzle (3) into the add-on faucet (1), screw the nut (2).

  6. connect the longer riser (3) with the other side of the add-on faucet (1), Screw the thread (2) tightly.

  7. Fix one side of the wall bracket (4) onto the wall .

  8. Unscrew the other side of the wall bracket (1) and put the longer riser inside (5).
     Screw the other side of the bracket (1) after adjusting the height of the wall bracket.

  9. Insert the brass tube (3) into wall bracket (4),use the Allen wrench to fix the brass tube (3) and the bracket (4).
     Distance from wall MAX 160mm.
     Cut the brass tube (3) if the faucet to the wall is <160mm.

  10. Screw the hook (2) after adjusting the height with the screwdriver.

  11. Connect the other side of the longer riser (1)to the flexible hose(5) , do remember the gasket (3) inside and the connector (4) must be tightly screwed.
      Adjusting the height of the bracket(2).

  12. Connect the other side of the fleible tube (6) with the spray(8) , do remember the gasket (7) inside .

FLUSH SYSTEM/CHECK FOR LEAKS.
Turn on hot and cold water supplies and flush water lines for one minute.
Check all connections at arrows for leaks.
Retighten if necessary, but do not overtighten.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>