ARCORA AR7104800G Deck Mount Pot Filler Instruction Manual
- June 12, 2024
- ARCORA
Table of Contents
POT FILLER FAUCETS
1.8GPM 6.8L/min
unit:inch(mm)
AR7104800G Deck Mount Pot Filler
Instruction Manual
You may need
For easy installation of your faucet you will need:
To READ ALL the instructions completely before beginning.
To READ ALL warnings, care, and maintenance information.
Application
Faucet are designed for delivering cold water from a main supply.
Faucet can be positioned above sinks or stoves and the articulated nature of
the spout enables the outlet to be conveniently positioned above pots / pans
as required.
Installation
Note:
When installing on plasterboard walls (not solid walls) it must be assured
that an appropriate reinforcement is in place to ensure sufficient strength.
Flush pipes thoroughly!
Cleaning and Care
Care should be given to the cleaning of this product. Although its finish is
extremely durable,
It can be damaged by harsh abrasives or polish.
To clean, simply wipe gently with a damp cloth and blot dry with a soft
towel.With 1.8 gpm are compliant with California water effi ciency
regulations, Complies with California Proposition 65 and with the Federal Safe
Drinking Water Act.
In areas with extremely low water pressure causing the faucet water flow to be
unsatisfactory , replace the aerator to improve the water flow in the faucet.
Notice:
Cold water connection only
Simple on/off control by rotating handle 90 (1/4 turn)
Shut off both handle cartridges when not in use or left unattended. Improper
use or inadequate drainage below faucet may cause water damage.
Notice
Before installing the valves, clean the water pipe thoroughly to avoid dirt
and deposits.
1.Screw the base(2) under the body .
1.Make sure attach the O-ring(3) to the base.
2. Make sure the handle stick is facing user when it is off, turn the handle
90° clockwise to open the tap. Correct installation will aviod the stick
touching wall.
- Place washer(2) over mounting stud under sink.
- Screw hexagonal lock nut (3) on to threaded rod (1) and tighten.
-
When the sink hole size is Φ35mm, please tighten the fixing nut (2)to the thread rod (1)and keep it horizontal with the counter.
-
Place washer(3) and metal plate(4) over mounting stud under sink.
-
Screw hexagonal lock nut (5) on to threaded rod (1) and tighten.
-
Use the triangle fastener(2) when the thickness of sink <5mm.
-
Place Triangle fastener(2) and washer(3) and metal plate(4) over mounting stud(1) under sink.
Secure with mounting nut(5) .
Attach supply lines .
Do not overtighten.
Turn water back on.
5. Remove aerator (1) and turn faucet handles (2) to the full on position.
Turn on cold water supplies and flush water lines for one minute.
Important: This flushes away any debris that could cause damage to internal
parts.
Check all connections at arrow for leaks.
Re-tighten if necessary, but do not overtighten.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>