ARCORA AR6101400C 4 Inch Centerset Double-Handle High Arc Bathroom Faucet Instruction Manual
- June 12, 2024
- ARCORA
Table of Contents
ARCORA AR6101400C 4 Inch Centerset Double-Handle High Arc Bathroom Faucet
You may need
For easy installation of your faucet you will need:
To READ ALL the instructions completely before beginning. To READ ALL warnings, care, and maintenance information.
Cleaning and Care
Care should be given to the cleaning of this product. Although its finish is
extremely durable, It can be damaged by harsh abrasives or polish. To clean,
simply wipe gently with a damp cloth and blot dry with a soft towel.
With 1.2 gpm are compliant with California water efficiency regulations,
comply with California Proposition 65 and with the Federal Safe Drinking Water
Act.
In areas with extremely low water pressure causing the basin faucet water flow
to be unsatisfactory, replace the 2.2 gpm aerator to improve the water flow in
the basin faucet.
Maintenance
If faucet exhibits very low flow:
- A. Remove and clean aerator(2) with hand,
- B. Shut off water supply valves. Replace valve assembly (4).
When reinstalling parts, make sure bonnet nut (5) is tightened securely with a wrench.
If faucet leaks from under handle: Using a wrench, ensure bonnet nut (5)
is tight.
If leak persists: Shut off water supply valves. Replace valve assembly (4
). When reinstalling parts, make sure bonnet nut (5)is tightened securely with
a wrench.
If faucet leaks from spout outlet: Shut off water supply valves. Replace valve assembly (4). When reinstalling parts, make sure bonnet nut (5) is tightened securely with a wrench. Install valve assembly(4) correctly for proper handle rotation.
DIMENSION
OPERATION
- Double levers style handles
- Maximum handle(s) rotation angle is 90
- Rotate hot side counterclockwise to open (clockwise to close)
- Rotate cold side clockwise to open (counterclockwise to close)
NOTE
-
Before installing the valves, clean the water pipe thoroughly to avoid dirt and deposits.
-
Provided with necessary models.
OPTION: Use silicone under the base if deck is uneven. -
Attach the mounting nut to the hot and cold threaded mounting shanks and tighten faucet to basin.
-
Attach supply lines . Do not over tighten. Turn water back on.
To flush debris from the plumbing system:
- Remove the aerator by hand.
- Run hot and cold water for one minute.
- Replace the aerator.
FLUSH SYSTEM/CHECK FOR LEAKS.
Turn on hot and cold water supplies and flush water lines for one minute.
Check all connections at arrows for leaks. Retighten if necessary, but do not
overtighten.
INSTALLATION
- A. Remove stopper (1 )and flange (2).
- B. Screw nut (1) all the way down. Push washer (2) and gasket (3) down.
- C. Apply silicone to underside of flange (1 ).Insert body (2) into sink. Screw flange (1) into body (2).
- D. Pivot (1) must face faucet. Pull assembly (2) down firmly and hold in place. DO NOT TWIST.
- E. Tighten nut I washer/ gasket (1 ), clean off excess silicone (2). DO NOT TWIST
- F. Remove pivot nut (1 ). Install horizontal rod (2) and stopper(3) as removable (4) or non-removable(S). Hand tighten pivot nut (1 ).
- G. Attach horizontal rod (1) to strap (2) using clip (3). Insert lift rod (4) into strap and tighten
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>