VISUAL COMFORT JN 2045 Alberto Extra Large Three Tier Sconce Instruction Manual
- June 12, 2024
- VISUAL COMFORT
Table of Contents
COMFORT JN 2045 Alberto Extra Large Three Tier Sconce
Product Information
Product Name: Alberto Extra Large Three Tier Sconce
Item Number: JN 2045
This light fixture is designed to be installed in accordance with local
installation codes by a person familiar with its construction and operation.
It is important to inspect the item and its contents for any damage or defects
before installation. Retain all packaging materials until installation is
complete and approved.
Tools Required (Not Included)
- Phillips Screwdriver
- Slotted Screwdriver
Product Usage Instructions
- Carefully remove all parts from the box and place them on a clean, soft surface.
- Using a Phillips screwdriver, remove the screws holding the mounting plate (A) to the fixture (E).
- Install the mounting plate (A) to the junction box and secure it with the provided mounting screws (B).
- Wrap the fixture ground wire (bare copper) around the green grounding screw on the mounting plate.
Care Instructions
- Clean the fixture only with a soft dry cloth or feather duster.
- Avoid using abrasive or chemical agents.
- This product is UL listed.
ASSEMBLY INSTRUCTIONS
Alberto Extra Large Three Tier Sconce
Item # JN 2045
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED
(NOT INCLUDED):
- Phillips Screwdriver
- Slotted Screwdriver
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (A) from fixture (E) by removing screws (D).
-
Install mounting plate (A) to the junction box and secure with mounting screws (B).
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (C).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (C).
-
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (C).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install fixture (E) to mounting plate (A) and secure with screws (D).
Care Instructions
Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>