B TECH BT5963 CCTV Ceiling TV Mount Installation Guide
- June 4, 2024
- B-TECH
Table of Contents
B TECH BT5963 CCTV Ceiling TV Mount
SPECIFICATIONS
- Mounts a screen and a dome camera from the ceiling
- Max load: 20kg (screen) / 5kg (camera)
- Available in two Ø38mm pole lengths: BT5963-FD100 pole length 1000mm BT5963-FD200 pole length 2000mm
- Recommended for screens up to 28”
- Suitable for screens with VESA® fixings: 75 x 75mm & 100 x 100mm
- Screen tilt adjustment: +17° / -10°
- Carousel suitable for cameras with fixings from 51mm up to 127.5mm apart
- Integrated cable management
INSTALLATION SAFETY INSTRUCTIONS
This mount is intended for use only with the maximum weights indicated. Use with equipment heavier than the maximum indicated may result in instability causing possible injury
Do not attempt to install this product until all instructions and warnings have been read and properly understood. Please keep these instructions for future reference. Please check carefully to make sure there are no missing or defective parts – defective parts must never be used. B-Tech AV Mounts, its distributors and dealers are not liable or responsible for damage or injury caused by improper installation, improper use or failure to observe these safety instructions. In such cases, all guarantees will expire.
General
B-Tech AV Mounts recommends that a professional AV installer or other suitably qualified person install this product. Great care must always be taken during installation as most AV equipment is of a fragile nature, possibly heavy and easily damaged if dropped. If you do not fully understand the instructions or are not sure how to install this product safely, then please consult a professional for advice and/or to install this product for you. Failure to mount this product correctly may cause serious injury or death, both during installation and at any time thereafter. Do not mount any AV equipment that exceeds the specific weight limit of the product you are installing. This weight limit will be clearly stated on each product and its packaging and will vary from product to product.
Product location
Please pay careful attention to where this product is located. Check load
capacity of the ceiling prior to installation as some surfaces are not
suitable for installation. Designed for indoor use, this mount is suitable for
public or home installation If located in a public or frequently populated
area ensure that the product is out of the immediate reach of people. If any
AV equipment is to be suspended over the likely path or location of people
then great care should be taken to secure all parts of the installation from
falling. When drilling holes it is essential to avoid contact with electrical
cables and water or gas pipes contained within. Use of a good quality live
wire detector and hidden object locator is therefore recommended. Only drill
into structures when you are sure it is safe to do so.
Fixing hardware
It is highly recommended that all fixing screws be used where supplied and
that the purpose of all other fixing hardware is fully understood. In some
cases more AV equipment fixing hardware will be supplied to accommodate
different models of equipment and set up configurations. The installer must be
satisfied that any supplied fixing hardware is suitable for each specific
installation. If any fixing screws or included hardware are deemed not
sufficient for a safe installation then please consult a professional or your
local hardware store.
Hazard limitation
When routing cables take advantage of any built in cable management
features that the product might provide and ensure that all cables are tidy
and secure. Check to see that any moving aspect of the product can do so
unhindered by any cabling. Some products have moving parts and the potential
to cause injury through the crushing or trapping of fingers or other body
parts. Particular attention to the nature of moving parts is required
especially when assembling installing and adjusting during set up. Immediately
after installation double-check that the work done is safe and secure. Double-
check all necessary fixings are present and are of ample tightness. It is
recommended that periodic inspections of the product and its fixing points are
made as frequently as possible (no more than 6 months apart) to ensure that
safety is maintained. If in doubt consult a professional AV installer or
another suitably qualified person.
PARTS LIST
-
CEILING PLATE 1
-
M8 x 10mm HEX SCREW 2
-
M6 x 5mm HEX GRUB SCREW 6
-
Ø38mm POLE 1
-
CEILING COVER PLATE 2
-
Ø38mm COLLAR 1
-
M8 x 12mm HEX SCREW 4
-
M6 x 8mm HEX GRUB SCREW 2
-
COLLAR COVER PLATE 2
-
MOUNTING PLATE 1
-
INTERFACE PLATE 1
-
M8 x 12mm PIN HEX SCREW 4
-
M8 WASHER 4
-
CAROUSEL INTERFACE 1
-
M4 x 12mm PIN HEX SCREEN 4
-
M4 x 12mm SCREW 4
-
M4 METAL WASHER 4
-
M4 NUT 4
-
M6 x 10mm SCREW 4
-
M6 WASHER 4
-
M6 NUT 4
-
3AF HEX KEY 1
-
4AF PIN HEX KEY 1
-
5AF HEX KEY 1
-
5AF LONG PIN HEX KEY 1
INSTALLATION TOOLS REQUIRED
INSTALLATION INSTRUCTIONS
MOUNT CEILING PLATE TO CEILING
-
1. Pre-drill holes for ceiling fixings (not supplied). -
Assemble two fixing screws on opposite sides, leaving a 10mm gap between the screw head and ceiling
-
Hook item 1 onto the fixing screws and twist into position.
-
Add remaining ceiling fixings and tighten all screws.
FIX POLE TO CEILING PLATE
- Insert item 4 into item 1 and secure in place with item 2.
- Tighten item 3, fixing item 4 to item 1.
- Fit item 5 to item 1
FIX MOUNTING PLATE ONTO POLE
-
Attach item 10 to item 6 using item 7
Note: Ensure item 8 is positioned on the back of item 6. -
Slide item 6 up item 4 and secure at desired height by tightening item 8.
FIX CAROUSEL INTERFACE TO POLE
- Attach item 14 to the bottom of item 4 using item 2.
- Tighten item 3, securing item 14 to item 4.
ATTACH CAMERA TO CAROUSEL INTERFACE
- Fix the camera to item 14 using items 16-21.
FIX INTERFACE PLATE TO SCREEN
- Attach item 11 to the rear of the screen using item 15.
HOOK SCREEN ONTO MOUNTING PLATE
- Hook item 11 onto item 10.
SECURE SCREEN
- On both sides of item 7 insert items 12 & 13 securing the screen to the mount.
Note: Do not fully tighten item 12 until screen tilt is set.
DIMENSIONS
CEILING MOUNT
SCREEN INTERFACE
CAROUSEL INTERFACE
Documents / Resources
| B
TECH BT5963 CCTV Ceiling TV
Mount
[pdf] Installation Guide
BT5963, CCTV Ceiling TV Mount, Ceiling TV Mount, TV Mount, BT5963, Ceiling
Mount
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>