ricoo FS0112 Monitor Stand Instruction Manual
- June 12, 2024
- ricoo
Table of Contents
ricoo FS0112 Monitor Stand
Product Information: – Manufacturer: E.N.Z. Engineering GmbH –
Model: Unknown – Address: Salzmatten 6, 79341 Kenzingen (Germany)
Load Weight Limit: Maximum 20kg (44lbs)
Languages : DE, EN, FR, ES, IT
Contact Information: – -Mail: [email protected]
Website : www.ricoo.eu
Product Usage Instructions
- Before starting assembly, make sure you have read and understood all the instructions and warnings provided in the assembly manual. If you have any questions regarding the instructions or warnings, contact the manufacturer’s support.
Scope of Delivery:
- A x1 – B x3 – C x6 – D x6 – E x1 3.
Assembly:
- a) Start by attaching part A to part D using the provided screws.
- b) Attach part B to part D using the provided screws.
- c) Repeat step b) for the remaining two parts B.
- d) Attach part C to part D using the provided screws.
- e) Repeat step d) for the remaining five parts C.
- f) Finally, attach part E to complete the assembly.
Load Weight Limit Warning:
- Do not exceed the listed load weight limit of 20kg (44lbs).
- Exceeding this limit may result in property damage or serious injury.
Completion:
- Once assembly is finished, ensure that all parts are securely attached.
- Verify that the load weight does not exceed the specified limit.
- Confirm that the product is stable and properly balanced.
- For any further assistance or inquiries, contact the manufacturer’s support via email or visit their website.
Warning
Do not exceed listed load weight. Property damage oder serious injury may
occur!
NOTE : READ THE ENTIRE INSTRUCTION MANUAL BEFORE YOU START INSTALLATION
AND ASSEMBLY
Please note: Images in these assembly instructions are only technical
presentation of the product. Actual product design may vary minimally.
- Do not begin the installation until you have read and understood all the instructions and warnings contained in this installation sheet. If you have any questions regarding any of the instructions or warnings, please contact your local distributor. This product was designed to be installed and used ONLY as specified in this manual. Improper installation of this product may cause damage or serious injury. This product may only be assembled / installed by the technical staff.
- Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
- Always use an assistant or mechanical lifting equipment to safely lift and position the equipment. Make sure that before and after the installation of the product neither you nor somebody else can be injured and other objects can be damaged. In case of doubt request for help from an expert. This product is intentded for indoor use only. Using this product outdoors could lead to product failure and personal injury. Tighten screws firmly, but do not over tighten. Over tightening can cause damage the items, this greatly reduces their holding power.
Scope of delivery
Assembly Instructions
E-Mail: [email protected]
www.ricoo.eu
E.N.Z. Engineering GmbH
Salzmatten 6
79341 Kenzingen
(Germany)