RICOO-S4511 v2008 User Manual
- June 6, 2024
- ricoo
Table of Contents
RICOO-S4511 v2008 User Manual
Warning: Do not exceed listed load weight. Property damage oder serious injury may occur!
NOTE: READ THE ENTIRE INSTRUCTION MANUAL BEFORE YOU START INSTALLATION AND
ASSEMBLY
Please note: Images in these assembly instructions are only technical
presentation of the product. Actual product design may vary minimally.
Do not begin the installation until you have read and understood all the
instructions and warnings contained in this installation sheet. If you have
any questions regarding any of the instructions or warnings, please contact
your local distributor. This product was designed to be installed and used
ONLY as specified in this manual. Improper installation of this product may
cause damage or serious injury. This product may only be assembled/installed
by the technical staff. Make sure that the supporting surface will safely
support the combined weight of the equipment and all attached hardware and
components. Always use an assistant or mechanical lifting equipment to safely
lift and position the equipment. Make sure that before and after the
installation of the product neither you nor somebody else can be injured and
other objects can be damaged. In case of doubt request for help from an
expert. This product is intended for indoor use only. Using this product
outdoors could lead to product failure and personal injury. Tighten screws
firmly, but do not over tighten. Over tightening can cause damage the items,
this greatly reduces their holding power.
We recommend using a professional level.
Installation
Step 1:
Please check BEFORE installation distance between VESA mounting holes on your
display!
VESA – Hole distance = Distances between the mounting holes on the screen
back.
Step 2:
Warning: Supplied plastic anchors are only suitable for solid concrete walls!
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
WARNING: Perform the tension-balance adjustment only after the screen
assembly! This operation must be carried out only with the Allen key!
Please keep the arm level during tension adjustment. Use a proper Allen key to
slightly loosen or tighten the adjustment screw according to the display
weight.
If display settles on its own, rotate adjustment screw towards the “+” symbol.
If display rises on its own, rotate adjustment screw towards the “-” symbol.
DURING THE LATER REMOVING OF THE DISPLAY MAKE SURE THE FRONT ARM IS ON TOP
BEFORE TAKING OFF THE DISPLAY!
Attention: The arm can shoot up upwards because of the gas pressure
spring! If you don’t pay attention you can be injured.
Step 8:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>