RICOO S4911 v2008 Instruction Manual
- June 6, 2024
- ricoo
Table of Contents
RICOO
S4911 v2008 Instruction Manual
Warning: Do not exceed listed load weight. Property damage oder serious injury may occur!
NOTE: READ THE ENTIRE INSTRUCTION MANUAL BEFORE YOU START INSTALLATION AND
ASSEMBLY
Please note: Images in these assembly instructions are only technical
presentation of the product. Actual product design may vary minimally. Do not
begin the installation until you have read and understood all the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your local
distributor. This product was designed to be installed and used ONLY as
specified in this manual. Improper installation of this product may cause
damage or serious injury. This product may only be assembled/installed by the
technical staff. Make sure that the supporting surface will safely support the
combined weight of the equipment and all attached hardware and components.
Always use an assistant or mechanical lifting equipment to safely lift and
position the equipment. Make sure that before and after the installation of
the product neither you nor somebody else can be injured and other objects can
be damaged. In case of doubt request help from an expert. This product is
intended for indoor use only. Using this product outdoors could lead to
product failure and personal injury.
Tighten screws firmly, but do not overtighten. Over tightening can cause damage to the items, this greatly reduces their holding power. By reason of large television construction types on the market, we can’t adjust our screen installation materials for each screen type. Therefore it is possible that the screws which are numerously delivered don’t fit with your TV/Monitor. We ask for your understanding that we can’t cover up all possibilities of many screen types. Each wall is built up of different materials which can result in a special requirement. Therefore we are concentrated on the delivery of installation materials only for mass concrete walls. Use our included installation accessories only for mass concrete walls. When mounting on the wall of the wooden beam, make sure that the fastening screws are anchored in the center of the beams. It is highly recommended to use a beamfinder. If your walls have a special demand for materials, we advise you to ask an expert shop for a suitable acquirement of the installation materials.
Tools
We recommend using a professional level.
Installation
Step1:
Please check BEFORE installation distance between VESA mounting holes on your
display!
VESA – Hole distance = Distances between the mounting holes on the screen
back.
Step 2:
Step 3:
Use the matching screws and spacers for your display.
Step 4:
Step 5:
WARNING: Perform the tension-balance adjustment only after the screen
assembly! This operation must be carried out only with the Allen key!
Please keep the arm level during tension adjustment. Use a proper Allen key to
slightly loosen or tighten the adjustment screw according to the display
weight.
If the display settles on its own, rotate the adjustment screw towards the “+”
symbol.
If the display rises on its own, rotate the adjustment screw towards the “-”
symbol.
DURING THE LATER REMOVING OF THE DISPLAY MAKE SURE THE FRONT ARM IS ON TOP
BEFORE TAKING OFF THE DISPLAY!
Attention: The arm can shoot up upwards because of the gas pressure
spring! If you don’t pay attention you can be injured.
Step 6:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>