RICOO FE6244 v2008 Instruction Manual
- June 6, 2024
- ricoo
Table of Contents
RICOO FE6244 v2008
Warning: Do not exceed listed load weight. Property damage oder serious injury may occur!
NOTE: READ THE ENTIRE INSTRUCTION MANUAL BEFORE YOU START INSTALLATION
AND ASSEMBLY
Please note: Images in these assembly instructions are only technical
presentation of the product. Actual product design may vary minimally.
Do not begin the installation until you have read and understood all the
instructions and warnings contained in this installation sheet. If you have
any questions regarding any of the instructions or warnings, please contact
your local distributor. This product was designed to be installed and used
ONLY as specified in this manual. Improper installation of this product may
cause damage or serious injury. This product may only be assembled / installed
by the technical staff. Make sure that the supporting surface will safely
support the combined weight of the equipment and all attached hardware and
components. Always use an assistant or mechanical lifting equipment to safely
lift and position the equipment. Make sure that before and after the
installation of the product neither you nor somebody else can be injured and
other objects can be damaged. In case of doubt request for help from an
expert. This product is intended for indoor use only. Using this product
outdoors could lead to product failure and personal injury. Tighten screws
firmly, but do not over tighten. Over tightening can cause damage the items,
this greatly reduces their holding power.
By reason of large television construction types on the market, we can’t adjust our screen installation materials for each screen type. Therefore it is possible that the screws which are numerously delivered don’t fit with your TV/Monitor. We ask for your understanding that we can’t cover up all possibilities of many screen types.
The numbering on the plastic bag may differ / missing completely!
Dimensions
Please check BEFORE installation distance between VESA mounting holes on your
display!
VESA – Hole distance = Distances between the mounting holes on the screen
back.
Connection
How to Assembly
Remote Stand
Mounting
Use the matching screws and spacers for your display.
If the screws “M-C, M-D” are too long, use the plastic spacers “M-G, M-H”. (like in Step 10 A)
Fix on mount
Indicators
- PLEASE DON’T USE THE PRODUCT OUTSIDE THE TEMPERATURE RANGE: -5° C ~ +40° C
- PLEASE STOP FOR 4 MINUTES WHEN CONTINUALLY OPERATING FOR 30 SECONDS.
UPWARD MOVEMENT:
Press the “ ”-button to lift the TV, it can be stopped by prassing STOP- or “
”-button during the process.
DOWNWARD MOVEMENT:
Press the “ ”-button to lower the TV, it can be stopped by prassing STOP- or “
”-button during the process.
NOTE: If the mount stopped at the HIGHEST / LOWEST position for less than
5 minutes, please press the / button twice to activate the height adjustment
mode.
E-Mail: support@ricoo.de
www.ricoo.eu
Tel: +49 (0) 7644-565310
Fax: +49 (0) 7644-5653199