ricoo S9222 Height Adjustable Monitor Mount Instruction Manual
- June 12, 2024
- ricoo
Table of Contents
**ricoo S9222 Height Adjustable Monitor Mount Instruction Manual
**
Warning: Do not exceed listed load weight. Property damage oder serious injury may occur!
Please check BEFORE installation distance between VESA mounting holes on your display!
This screen mount supports VESA hole distance in the minimum and maximum distance ranges given above.
VESA – Hole distance = Distances between the mounting holes on the screen
back.
Scope of delivery
**** We recommend using a professional level.
**** The numbering on the plastic bag may differ / missing completely!
NOTE: READ THE ENTIRE INSTRUCTION MANUAL BEFORE YOU START INSTALLATION AND ASSEMBLY
Please note: Images in these assembly instructions are only technical
presentation of the product. Actual product design may vary minimally. Do not
begin the installation until you have read and understood all the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your local
distributor. This product was designed to be installed and used ONLY as
specified in this manual. Improper installation of this product may cause
damage or serious injury. This product may only be assembled / installed by
the technical staff. Make sure that the supporting surface will safely support
the combined weight of the equipment and all attached hardware and components.
Always use an assistant or mechanical lifting equipment to safely lift and
position the equipment. Make sure that before and after the installation of
the product neither you nor somebody else can be injured and other objects can
be damaged. In case of doubt request for help from an expert. This product is
intended for indoor use only. Using this product outdoors could lead to
product failure and personal injury. Tighten screws firmly, but do not over
tighten. Over tightening can cause damage the items, this greatly reduces
their holding power.
****By reason of large television construction types on the market, we can’t
adjust our screen installation materials for each screen type. Therefore it is
possible that the screws which are numerously delivered don’t fit with your
TV/Monitor. We ask for your understanding that we can’t cover up all
possibilities of many screen types.
Each wall is built up of different materials which can result a special
requirement. Therefore we are concentrated on the delivery of installation
materials only for mass concrete walls. Use our included installation
accessories only for mass concrete walls.
When mounting on the wooden beams wall, make sure that the fastening screws
are anchored in the center of the beams. It is highly recommended to use a
beamfinder. If your walls have a special demand of materials, we advise you to
ask in an expert shop for a suitable acquirement of the installation
materials.
Assembly Instruction
Warning: Supplied plastic anchors are only suitable for solid concrete
walls!
**** Use the matching screws and spacers for your display
**** Use the matching screws and spacers for your display
**** If the screws “M-D” are too long, use the plastic spacers “M-G”. (like
in Step 4 A)
WARNING: Perform the tension-balance adjustment only after the screen
assembly! This operation must be carried out only with the Allen key!
Please keep the arm level during tension adjustment. Use a proper Allen key to
slightly loosen or tighten the adjustment screw according to the display
weight.
If display settles on its own, rotate adjustment screw towards the “+” symbol.
If display rises on its own, rotate adjustment screw towards the “-” symbol.
DURING THE LATER REMOVING OF THE DISPLAY MAKE SURE THE FRONT ARM IS ON
TOP BEFORE TAKING OFF THE DISPLAY!
Attention: The arm can shoot up upwards because of the gas pressure
spring! If you don’t pay attention you can be injured.
Done!
E.N.Z. Engineering GmbH, Salzmatten 6, 79341 Kenzingen (Germany)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>