ricoo TS8811 Desk Mount for 2 Monitors Instruction Manual
- June 12, 2024
- ricoo
Table of Contents
ricoo TS8811 Desk Mount for 2 Monitors
Product Information:
- Product Name: TS8811
- Version: v.21.01
- Manufacturer: E.N.Z. Engineering GmbH
- Manufacturer Address: Salzmatten 6, 79341 Kenzingen (Germany)
- Email: support@ricoo.de
- Website: www.ricoo.eu
Product Usage Instructions:
-
Before installation, please check the distance between the VESA
mounting holes on your display. -
This screen mount supports VESA hole distances in the minimum
and maximum ranges provided. -
VESA hole distance refers to the distances between the mounting
holes on the back of the screen. -
Ensure not to exceed the listed load weight. Exceeding the load
weight may result in property damage or serious injury. -
Assembly Steps:
- Attach component A to your wall using the provided screws and a suitable wall mount.
- Attach components B, C, D, E, F, G, H, I, and J to component A using the provided screws as shown in the diagram.
- Attach your display to the VESA mount on component J using the appropriate screws and ensure it is securely fastened.
- Adjust the position and angle of your display as desired.
- Ensure all connections are secure and cables are properly managed.
- Verify that the installation is complete and all components are properly attached.
- Your installation is now complete. Enjoy using your display with the TS8811 screen mount!
Warning: Do not exceed listed load weight. Property damage oder serious injury may occur!
Scope of delivery
We recommend using a professional leve
Please check BEFORE installation distance between VESA mounting holes on your
display!
This screen mount supports VESA hole distance in the minimum and maximum
distance ranges given above.
VESA – Hole distance = Distances between the mounting holes on the screen back
NOTE: READ THE ENTIRE INSTRUCTION MANUAL BEFORE YOU START INSTALLATION AND ASSEMBLY
- Please note: Images in these assembly instructions are only technical presentations of the product. Actual product design may vary minimally.
- Do not begin the installation until you have read and understood all the instructions and warnings contained in this installation sheet.
- If you have any questions regarding any of the instructions or warnings, please contact your local distributor.
- This product was designed to be installed and used ONLY as specified in this manual. Improper installation of this product may cause damage or serious injury.
- This product may only be assembled/installed by the technical staff. Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
- Always use an assistant or mechanical lifting equipment to safely lift and position the equipment. Make sure that before and after the installation of the product neither you nor somebody else can be injured and other objects can be damaged. In case of doubt request for help from an expert. This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury. Tighten screws firmly, but do not over-tighten. Over-tightening can cause damage the items, this greatly reduces their holding power.
- By reason of large television construction types on the market, we can’t adjust our screen installation materials for each screen type. Therefore it is possible that the screws which are numerously delivered don’t fit with your TV/Monitor. We ask for your understanding that we can’t cover up all possibilities of many screen types.
- When mounting on the wooden beams wall, make sure that the fastening screws are anchored in the center of the beams. It is highly recommended to use a beam finder.
- If your walls have a special demand of materials, we advise you to ask in an expert shop for a suitable acquirement of the installation materials.
ASSEMBLY INSTRUCTION
WARNING
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>