ricoo TRH-07 Calculator Bracket for Wall Mounting Instruction Manual
- June 12, 2024
- ricoo
Table of Contents
Assembly Instructions
v.21.11
TRH-07 Calculator Bracket for Wall Mounting
Warning: Do not exceed listed load weight. Property damage oder serious injury may occur!
Scope of delivery
TRH-07
E-Mail:support@ricoo.de
www.ricoo.eu
E.N.Z. Engineering GmbH
Salzmatten 6, 79341 Kenzingen
(Germany)
NOTE: Read the entire instruction manual before you start installation and assembly
-
Please note: Images in these assembly instructions are only technical presentation of the product. Actual product design may vary minimally.
-
Do not begin the installation until you have read and understood all the instructions and warnings contained in this installation sheet. If you have any questions regarding any of the instructions or
warnings, please contact your local distributor. -
This product was designed to be installed and used ONLY as specified in this manual. Improper installation of this product may cause damage or serious injury.
-
This product may only be assembled / installed by the technical staff.
-
Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
-
Always use an assistant or mechanical lifting equipment to safely lift and position the equipment.
-
Tighten screws firmly, but do not over tighten. Over tightening can cause damage the items, this greatly reduces their holding power.
-
This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
-
Make sure that before and after the installation of the product neither you nor somebody else can be injured and other objects can be damaged. In case of doubt request for help from an expert.
-
Make also sure that you and optionally the co-helper or representatives have registered the mounting instructions before the installation and also the warning notice.
Warning: Supplied plastic anchors are only suitable for solid concrete walls!
Done!
E.N.Z. Engineering GmbH, Salzmatten 6, 79341 Kenzingen (Germany)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>