V-TAC VT-82-3D LED Chandelier Instruction Manual
- June 12, 2024
- V TAC
Table of Contents
**V-TAC VT-82-3D LED Chandelier
**
TECHNICAL DATA
| MODEL | VT-82-3D |
|---|---|
| WATTS | 86W |
| LUMENS | 4550LM |
| BEAM ANGLE | 360° |
| MATERIAL | Aluminum+Acrylic |
| BASE SIZE | ⌀600*42mm |
| DIMENSION | ⌀600/500/400mm |
| INPUT POWER | AC: 220-240V, 50Hz |
INTRODUCTION & WARRANTY
Thank you for selecting and buying V-TAC product. V-TAC will serve you the
best. Please read these instructions carefully before starting the
installation and keep this manual handy for future reference. If you have any
another query, please contact our dealer or local vendor from whom you have
purchased the product. They are trained and ready to serve you at the best.
The warranty is valid for 3 years from the date of purchase. The warranty does
not apply to damage caused by incorrect installation or abnormal wear and
tear. The company gives no warranty against damage to any surface due to
incorrect removal and installation of the product. The products are suitable
for 10-12 Hours Daily operation. Usage of product for 24 Hours a day would
void the warranty. This product is warranted for manufacturing defects only.
WARNING!
- Please make sure to turn off the power before starting the installation.
- Installation must be performed by a qualified electrician.
- The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
- Proper grounding should be ensured throughout the installation.
- For Indoor Use only
This marking indicates that this product should not be disposed of with other household wastes.
Caution, risk of electric shock.
INSTALLATION DIAGRAM:
-
Switch off the power before starting the installation.
-
Use screws to fix mounting bar to the junction box.
-
Make the wire connections with connectors .
• Connect the live wire (L) from fitting to the live wire from main power supply.
• Connect the neutral wire (N) from fitting to the neutral wire from main power supply.
• Connect the earth wire from fitting to the earth wire from main power supply.
• Please pay close attention and make sure the wires are not exposed outside when wiring connections. -
Use screws to fix canopy to mounting bar .
-
Check if the installation is completed and turn on the power.
Note: This light is designed with adjustable height, press the pin on the canopy to adjust the height of the light.
WIRING DIAGRAM
- Neutral Supply can be Blue or Black
- Ground Supply Can be Green-yellow
- Live Supply Can be Red or Brown
IN CASE OF ANY QUERY/ISSUE WITH THE PRODUCT, PLEASE REACH OUT TO US AT:
SUPPORT@V-TAC.EU
FOR MORE PRODUCTS RANGE, INQUIRY PLEASE CONTACT OUR DISTRIBUTOR OR NEAREST
DEALERS.
V-TAC EUROPE LTD. BULGARIA, PLOVDIV 4000, BUL.L.KARAVELOW 9B
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>