AVA Bullet Cloud Camera Installation Guide
- June 12, 2024
- AVA
Table of Contents
- Box content
- Using the wall bracket
- Opening the housing and removing cable gland
- Installing the camera on to the wall bracket
- Installing cable gland and connecting ethernet cable
- Connect the camera and adjust the picture
- Change lens orientation, horizontal (16:9) – vertical (9:16)
- Documents / Resources
AVA Bullet Cloud Camera
Important warnings and safety
instructions
Avoid exposing the camera to shocks, high pressure or temperatures above 50oC.
Avoid placing the camera near fans, ventilation or other noise sources. This
will degrade audio performance.
Avoid scratching or leaving fingerprints on the lens cover, this degrades
image quality. If possible, keep the protective plastic on the lens cover
during installation.
Do not clean the camera with harsh detergents, gasoline or chemicals such as
Acetone.
Do not try to repair the unit yourself. Refer all servicing of the camera to
Ava or contact a reseller.
! This product should be supplied by a Power over Ethernet (PoE) Power
Sourcing Equipment (PSE) compliant to IEEE 802.3af.
The PSE should be UL listed and marked “Limited Power Source” or “LPS”. The
output should be rated 48V and 12W minimum from the connected port.
! The camera and the PoE PSE must be installed within the same building,
as described by Environment A of the IEEE 802.3af standard. The PoE PSE must
be properly grounded.
Box content
Using the wall bracket
Screws are not included. The installer must use suitable fasteners.
Opening the housing and removing cable gland
**** It’s easier to access the screws when the ball joint is moved to an angle.
Installing the camera on to the wall bracket
Installing cable gland and connecting ethernet cable
Connect the camera and adjust the picture
Add the Camera to Ava Aware and ensure that the video stream is working.
Close the camera and tighten the two screws on the rear cover.
When the correct position is obtained, firmly tighten the screws (3-4Nm) to
lock the position.
Change lens orientation, horizontal (16:9) – vertical (9:16)
Ensure the camera body has been opened before attempting to rotate the lens.
Documents / Resources
| AVA
Bullet Cloud
Camera
[pdf] Installation Guide
Bullet Cloud Camera, Bullet, Cloud Camera, Camera
---|---