AVA FS-IC324 Induction Cooker Instruction Manual

AVA FS-IC324 Induction Cooker

SAFETY STATEMENTS

Before using the appliance, please read instructions carefully:

• Do no touch hot surfaces. Use handles or knobs.
• To protect against electrical shocks do not immerse the cord, plugs or the whole unit in water or other liquid. Close supervision is necessary when any appliance is used by or near children.
• Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off any parts.
• Do not operate the appliance with a damaged cord, plug or if the appliance has malfunctioned or been damaged in any manner.
• If faulty or damaged, return appliance to the nearest authorized service facility for examination, repair, or adjustment.
• Do not let the cord hang over the edge of a table of counter or touch hot surfaces.
• Do not place on or near hot gas, an electric burner or in a heated oven.
• Do not use the appliance for anything other than its intended use.
• Do not cook on a broken cooktop. If the cooktop should break, cleaning solutions and spillovers may penetrate the broken cooktop and create a risk of electric shock.
• Clean cooktop with caution. If a wet sponge or cloth is used to wipe spills on a hot cooking area, be careful to avoid getting burnt. So, cleaners can produce noxious fumes if applied to a hot surface.
• Do not place metallic objects such as knives, forks, spoons and lids on the appliance, as they can get hot.

PRODUCT OPERATING INSTRUCTIONS

ON/OFF

Insert the power cord into a suitable socket. You will hear a signal sound that indicates that you have connected the hob to a power source. The LED and control lights are briefly lit, press -ON/OFF, then the machine switches to STANDBY mode, and “C is displayed in the display

FUNCTION
Press the -Function to display the temperature. After selecting the function, press increase button (+) or decease button (-), set the degree or power.

TEMPERATURE AND POWER SETTINGS:

• In the standby mode, press the -Function to select the multi cooking function:
• The initial display on the screen is 1600(W)
• Press the (+ and (-) buttons to adjust the power
• The power can be adjusted in the following steps: 200 > 400 > 600 > 800> 1000 > 1200 > 1400 > 1600 > 1800 > 2000W
• Press the -Function again and select the temperature mode: The initial display on the screen is display 240(C)
• Press the (+) and (-) buttons to adjust the temperature.
• The Temperature can be adjusted in the following steps: 60°С> 80°С> 100°С> 120°C > 140°C> 160°С > 180°C > 200°C > 220°C > 240°C

TIMER

• Press -Timer to enter select the timer setup (from 1 minute to 240 minutes)
• Press or 1-I to set cooking time. Each single press is increment of 1 minute; press and hold for increments of 10 minutes.

LOCK

• Press -LOCK in 3 second to lock all the function.
• Press -LOCK in 3 second again to release the lock.

SELECTION OF COOKWARE

Material required

• Steel, cast iron, enameled iron, stainless steel, flat-bottom pans/pots with diameter from 12 to 26cm.
• Suggest to use the required pot, do not try to use other pot instead (especially pressure sensors vessels).

Please kindly according to the below requirement if necessary to use the vessel is not equipped:

• Pan/Pot must be suitable for induction cooker.
• Pan/Pot should be tried out if it’s bought by self to see if there are unusual phenomena.

MAINTENANCE AND DAILY CARE

• Remove the power plug prior to clean the unit. Do not clean it until the surface cools down.
• Glass Plate, Panel and Shell.
• Soft Cloth for slight stain. For greasy, dirt, blot by using a clean damp cloth with neutral detergent.
• While the radiator-fan working, dust and dirt would remain on the gas vent, please clean it by brush or cotton stick regularly.
• Remember do not washing the unit by water directly to avoid damaging.
• To protect induction cooker, be sure to have a good contact between plug and socket before using.
• Do not pull out the power cord directly during operation. To extend the appliance’s using life, press the [Mä/Tat]-On/Off button first, then pull out the power cord.
• In order to make operating time longer, the fan would still work for cooling the plate, is better to plug out after the fan stops working.
• Please pull out the power cord and put it away when not used for a long time

TROUBLESHOOTING AND TREATMENT

During operations, if any error occurred, please check the following table before calling for service. Below are common errors and the checks to perform :

If the above remedies/controls can not fix the problem, unplug the appliance immediately, contact service center for inspection and repairing, note the error code and report it to service center. To avoid any danger and damage to the appliance, do not disassemble or repair it by yourself.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>