AVA 213C81E443DA Conduit Back Box User Guide
- June 9, 2024
- AVA
Table of Contents
AVA 213C81E443DA Conduit Back Box
Box contents
Tools Required
-
T20 screwdriver
-
Suitable fasteners for your wall
Installing the conduit back box
4 Determine whether your camera features bracket type A or B
Bracket type A
A.5 Remove standard wall bracket
A.6 Please refer to the bullet camera mounting guide for cable management.
A.7 Lock the camera to the back box by tightening the 2x screws
Bracket type B
B.5 Loosen small set screw using the supplied L-key
Loosen the M6 set screw (T20)
Loosen the M6 set screw on the opposite side (T20)
B.6 Remove original bracket parts
B.7 Insert the included washer and assemble the new cove
B.8 Tighten the M6 set screw (T20)
Tighten the M6 set screw (T20) on the opposite side
The smallest set screw should sit right below flush (not tightened properly)
B.9 Please refer to the bullet camera mounting guide for cable management
B.10 Lock the camera to the back box by tightening the 2x screws B
AVA-CON-BCK-MG-01
Documents / Resources
| AVA
213C81E443DA Conduit Back
Box
[pdf] User Guide
213C81E443DA Conduit Back Box, 213C81E443DA, Conduit Back Box, Back Box, Box
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>