TAKAZONO GW-CB-S-002 S Cassetter Base Payout Unit User Manual
- June 12, 2024
- TAKAZONO
Table of Contents
User Manual for GW-CB-S-002
Introduction
Model: GW-CB-S-002
FCC ID: 2APN9GW-CB-S-002
This system is the payout unit of tablet chemicals.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
TAKAZONO AMERICA
3555 voyager st #102 Torrance CA 90503-1675 United States
1-310-542-8850
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely t cause harmful interference in which case the user
will be required to correct the interference at his own expense.
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment and meets the FCC radio frequency (RF) Exposure
Guidelines. This equipment should be installed and operated keeping the
radiator at least 20cm or more away from person’s body.
System Description
This system equipped with an RFID reader
/ writer and judges the type of tablet according to the contents of the set
“RFID tag” (mounted on “Tablet Cassette”).
The “Set switch” is turned on when “Tablet Cassette” is attached.
The type of “RFID tag” corresponds to ISO15693, and the conformity tags are
TT-I03-S1 (by HITACHI) or SFE-SLX-3025 (by E-Garde).
The tablet put in the cassette is paid out from the “Payout Opening” in the
required quantity, and counted by the “Count sensor”.
For the “Power supply”, DC12 V and DC5 V (for D5V and A5V) are required.
It operates by sending a CAN command from the “CAN Controller” via CANH, CANL.
“Status LED” is displayed in three colors (Red, Green, Orange) and it indicate
now status.
Connection
-
”Power connector” ・・・(HIROSE：DF-11-6DEP-2C)
1pin:12V、2pin:12VGND、3pin:D5V、4pin:D5VGND、5pin:A5V、6pin:A5VGND
＊1：Since each GND is not connected inside the unit, please connect
on the ”Power Supply” side. -
”Communication connector”・・・(HIROSE：DF-11-8DEP-2C)
1pin:CANH、2pin:CANL、3pin:(General-purpose Input)、4pin:CANH
5pin:CANL、6pin:(General-purpose Output)、7pin:termination、8pin:termination
＊2：If it is the
last node, please terminate CANH, L with built-in resistor (by wire).
Operating
- Supply to “Power connector” DC12V and DC5V (for D5V and A5V）
- Send the following CAN commands from “CAN controller”.
Command List
- Control Instruction
- State Response
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>