GERMAN POOL VSM-90 Vacuum Cleaner User Manual

GERMAN POOL VSM-90 Vacuum Cleaner

Product Information

Product Name: VSM-90-M-23(1)
Manufacturer: German Pool (Hong Kong) Limited
Manufacturer Address: Room 113, Newport Centre Phase II, 116 Ma Tau Kok Road, Tokwawan, Kowloon, Hong Kong
Contact Information: Tel: +852 2773 2888, Fax: +852 2765 8215

Distribution Locations:

• Hong Kong: Room 113, Newport Centre Phase II, 116 Ma Tau Kok Road, Tokwawan, Kowloon, Hong Kong
• China: 8th, Xinxiang Road, Wusha Industrial Park, Daliang, Shunde, Foshan, Guangdong
• Macau: A, 1 Andar, Mei Kui Kuong Cheong Fase 2, No.515 Avenida Do Conselheiro Borja

Contact Information for Distribution Locations:

• Hong Kong: Tel: +852 2773 2888, Fax: +852 2765 8215
• China: Tel: +86 757 2219 6888, Fax: +86 757 2219 6809
• Macau: Tel: +853 2875 2699, Fax: +853 2875 2661

Awards Received: HONG KONG TOP BRAND TEN YEAR ACHIEVEMENT AWARD

Website: www.germanpool.com

Product Usage Instructions

Please refer to the last page of this user manual for Warranty Terms & Conditions.

For detailed instructions on how to use the VSM-90-M-23(1) product, please follow the steps below:

1. Ensure the product is properly connected to a power source.
2. Refer to the product manual for specific operations and settings.
3. Follow the safety precautions mentioned in the manual before operating the product.
4. To register your warranty, please visit the manufacturer’s website or contact the respective distribution location.

If you have any further questions or need assistance, please contact German Pool (Hong Kong) Limited at the provided contact information.

Warnings & Safety Precautions

1. Check to make sure the voltage Indicated on rating label corresponds to the local mains voltage before you connect this product.

2. Please open the lid after the green light turns off.

3. If the power cord is damaged, in order to avoid a hazard, please be sure to replace It through the manufacturer, Its service agent, or related technical professionals.

4. When touching the plug, keep your hands dry.

5. Please unplug the plug before cleaning this product, and use a cloth whh a mild detergent to scrub and clean.

6. DO NOT place this product in a wet or dusty environment, please keep this product dry.

7. When not used for a long time or it thunders in summer, please take out the power plug.

8. DO NOT use more than one piece of electrical equipment on one outlet.

9. To protect against electric shock, DO NOT immerse any part or this product. its power cord or plug in water or other liquid. Unplug from the outlet when not in use and before cleaning.

10. To disconnect, unplug the power cord from the electrical outlet. DO NOT disconnect by pulling on the cord. This product is equipped with a detachable power cord which can be unplugged if not used for a long time.

11. DO NOT place on or near a hot gas or electric burner. or heated oven. Extreme caution must be paid when moving products containing hot liquids. Make sure not to exceed the maximum.

12. When defrosting foods in bags through the microwave, make sure not to exceed the maximum power of 180 watts,
    maximum time of 2 times, and maximum temperature of 1o•c (158F).

13. Close supervision is necessary to proceed when any appliance Is used near children to ensure they DO NOT play the appliance.

14. DO NOT use abrasive products or materials to clean any parts of this product. These cleaning materials will scratch the surface of this product and leave scratches on the surface of the panel.

15. This appliance can be used bY children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge If they have been given supervision or Instruction concerning use of the appliance In a safe way and understand the hazards involved. Children’s shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

Important Tips

1. During the vacuum sealing process. small amounts of liquids. crumbs. or food particles may be pulled into the vacuum tank in this product. To prevent such cases. follow these tips:
   For moist and juicy foods: freeze first and avoid overfilling bags.
   For soups, sauces, and liquids: freeze first, DO NOT overfilling, or just use a canister or container to put in the refrigerator. For powdery or fine- grained foods: DO NOT overfill, or just use a canister or container to put in the refrigerator.

2. When you are vacuum sealing items with sharp edges (dry spaghetti, silverware. etc.). protect the bag from punctures by wrapping items in soft cushioning material. such as a paper towel. You can use a canister or container instead of a bag.

3. Fresh fruits and vegetables are not suitable for vacuum storage at room temperature. because they have to breathe and they release heat while breathing, which can easily expand the bag. It is recommended that such items be packed in a preservation box and stored in the refrigerator for refrigeration.

4. It is required to wait for 40 seconds before the next operation when proceeding with vacuum sealing/ sealing only/external vacuum sealing. Continuous operation is not allowed in order to avoid machine overheating.

Product Structure

Main Body

1. High Mode
2. Low Mode
3. Seal Only Mode
4. Sealing Foam
5. Rubber Bar
6. Air Suction Hole
7. Heating Element
8. Vacuum Chamber
9. Sealing Foam
10. Lid Release Buttons
11. Vacuum Hose
12. Bag Cutter

Operation Instruction

Control Panel

****| High Mode|

• Press t his bu tt o n to vacuum and seal: v a cuu m sea l i n g powe r reaches-60k Pa . Suitable for items that need large suction force or when the vacuum bag needs to be vacuum sealed tightly, such as cereal, fruit, etc.
• High Mode Indicator light lights up Constantin green when vacuuming and sealing are in
• progress. Light will automatically turn off when the process Is done.

---|---|---
| Low Mode|

• Press this button to vacuum and seal; vacuum sealing power is -20kPa. Suitable for vacuum-sealing items that are so such as soft food, bread, etc.
• Low Mode Indicator light lights up constant in green when vacuuming and sealing are In
• progress. Light will automatically turn off when the process is done.

| ****

Seal Mode

|

• Press this button to seal bag only; bag will not be vacummed .
• Seal Mode indicator light lights up constant in green when sealing is in progress. Light will automatically turn off when sealing is done.

WARNING!

• DO NOT open the lid when the green light Is still on. otherwise vacuum and seating will not be completed. Only open the lid after the green light has turned off,
• The heating element may be hot to the touch after using. DO NOT touch to avoid getting burnt

How To Use

WARNING!
Soups. juices or other liquid foods MUST BE frozen first before vacuum- sealing. Vacuum-sealing food in liquid state will result in Juices overflowing Into \he product and causing malfunction or even electric shocks

1.  Connect to the power source. High/Low/ Seal Indicator lights light up simultaneously then go dark. and product enters standby state.
2. Push both Lid Release Buttons simultaneously to open the lid. then put the open end of bag into the vacuum chamber and Keep the bag flat.
3. Press the lid down on both sides at the same time untH you hear a click, indicating that the lid has closed properly.
4. Select desired mode. the corresponding Indicator light lights up constant. the product starts to vacuum and/or seal. When the process ts complete. the corresponding indicator light turns off.
5. Press both Lid Release Buttons simultaneously to open the lid and take out the sealed bag.

Note:

• The width of the bag must not exceed 30cm (11.8 inch).

• Choose the special textured bag with sealed sides for vacuum use. General bag with smooth surface is only used for sealing. If the open end of the bag is not laid flat into the vacuum chamber, the product will not vacuum or seal.

• If the lid is not closed properly (ie. no click is heard), the product will not vacuum or seal.

• There is a 40 second cooling period between each operation, this is to prevent the product from overheating. If user presses any button within the cooling period, all three indicator lights will light up simultaneously for 1 second then go
  dark, and product will not operate.

• Relax the lid when the product is not in use (no need to click shut). This will prolong the lifespan of the product.

Vacuum Tube

• Note:
  Vacuum canisters and vacuum containers are not included with this product.
  Vacuum tube can only be fitted onto vacuum container with a 5mm diameter accessory port.

1. Open the vacuum sealer lid. and fit the vacuum tube over the vacuum port.
2. Fit the other end of the vacuum tube into the accessory port of your vacuum canister or vacuum container.
3. Press HIGH or LOW mode to start vacuum process.
4. After vacuuming. remove the vacuum tube.

Bag Cutter
There is a bag cutter inserted at the back of the product for cutting vacuum bags.

Note:

• Please use a light hand when taking out the bag cutter, to avoid the cutter flicking out onto the floor.
• Put the bag cutter back into Its slot after use to prevent losing it

Cleaning and Maintenance

WARNING!

1. Unplug the product from the power source and allow it to cool down completely before cleaning and maintenance.
2. DO NOT Immerse the product or Its power cord in water or other liquid.
3. The sealing foam strips may be removed and rtnsed with water. The vacuum chamber and product surface may be wiped s with omit sponge or cloth.
4. DO NOT use hard brush to scrub the product in order to avoid scratching the surface, and DO NOT use any chemical solutions such as banana oil, benzine. alcohol. gasoline or bleach etc. to clean this product.
5. Let sealing foam strips and unit body air dry completely before reuse.

Troubleshooting

whether the product is properly plugged in
Product, power cord or plug may be damaged| Check the product, power cord and plug to see if there is any damage. If there is. discontinue use immediately and contact German Pool

Customer Service & Repair Centre

Product does not stop vacuuming and will not seal| The bag has holes| Change a new bag
The end of the bag has been placed in the vacuum chamber at a slanted angle| Put the end of bag squarely into the vacuum chamber
Sealing foam strip is damaged. chipped. flattened or deformed| Contact German Pool Customer Service &

Repair Centre for replacement

Product is damaged| Contact German Pool Customer Service &

Repair Centre

The bag doesn·t seal completely after vacuuming| Voltage is wrong| Check if the heating element is hot if it is hot, the voltage is wrong. Make sure to use the correct voltage that corresponds with the

product’s rating label

Product is damaged| If heating wire is not hot. the product is damaged. Contact German Pool Customer

Service & Repair Centre for repair

Part of bag does not seal| There is too much liquid in the food. It is not recommended to vacuum food with too much liquid
There is obstruction (eg. fold. grease. liquid or other substances) on the sealed end or

the opening of the bag

| Remove the obstruction
The lid was opened before the green light turned off| DO NOT open the lid when the green light is still on
The bag lost its vacuumed state after several days| The bag has small holes| Change a new bag
Vegetables and fruits release gas| This is a normal phenomenon
The bag does not vacuum completely even in High Mode| User has not used the special textur ed bag with sealed sides| Choose the special textured bag with sealed

sides for vacuum use

User tried to operate product within the 40 second cooling period| Wait 40 seconds between each operation
If product still does not vacuum completely after the above criteria are checked| Unplug the power supply, wait till product has cooled down completely then plug in and try again
The lid was opened before the green light turned off| DO NOT open the lid when the green light is still on
Product is damaged| Contact German Pool Customer Service & Repair Centre for repair
| Sponge strip has fallen off| Push it back into its slot. If it will not stay in place. stick it with double-sided tape|

WARNING!
If problem persists. contact German Pool Customer Service & Repair Centre for assistance_

Technical Specification

77 mm
Net Weight| 0.73 kg

Specification is subject to change without prior notice.
If there Is any Inconsistency or ambiguity between the English version and the Chinese version. the English version shall prevail.
Refer to www.germanpool.com for the most update version of the user manual.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>