Maisto 81550 Radio Control Vehicle Instruction Manual
- June 12, 2024
- 0 3 baby
Table of Contents
- 1:24 2.4GHz R/C
- 81550/#81514/#81515/#81516/#81517/#81518/#81519/#81520/#81521/#81522/#81523/#81524/#81525/#81526/#81527/#81528/#81529/#81530/#81531/#81532
- Maisto Radio Control Vehicles
- Contents:
- Battery Requirement:
- Battery Installation for the Transmitter: (Refer to Diagram 1)
- Battery installation for the Vehicle: (Refer to Diagram 2 & 3)
- How to play: (Refer to Diagram 4, 5 & 6)
- Performance Tips:
- Battery use:
- FCC Label Compliance Statement:
- RSS-210 Compliance Statement :
- Troubleshooting:
- Environmental notes:
- Disposal of batteries
- CE Declaration
- Maisto Radio Control Vehicles
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
1:24 2.4GHz R/C
Age 5+
81550/#81514/#81515/#81516/#81517/#81518/#81519/#81520/#81521/#81522/#81523/#81524/#81525/#81526/#81527/#81528/#81529/#81530/#81531/#81532
Maisto Radio Control Vehicles
Warning! Not suitable for children under 36 months, Small parts, Choking
hazard.
Please keep this owner’s instruction manual for future reference.
It contains important information.
We reserve the right to improve/revise the product specifications without
notice.
Contents:
Vehicle x 1
Transmitter x 1
Owner’s Instruction Manual x 1
Battery Requirement:
Vehicle: 2 x 1.5V “AA” LR6/R6 batteries.
Transmitter: 2 x 1.5V “AAA” LR03/R03 batteries.
Battery Installation for the Transmitter: (Refer to Diagram 1)
-
Use screwdriver to loosen the screw on the battery cover and to open the battery cover.
(Screwdriver is not included) -
Install 2 new 1.5V “AAA” LR03/R03 batteries with correct polarity (+/-) as shown inside the battery compartment.
-
Install the battery cover and then tighten the screw on the battery cover.
a) Battery Installation
- Screw
- Battery cover
- 2 x 1.5V “AAA”
LR03/R03 batteries
Battery installation for the Vehicle: (Refer to Diagram 2 & 3)
-
Switch the power OFF.
-
Use screwdriver to loosen the screw on the battery cover and to open the battery cover.
(Screwdriver is not included) -
Install 2 new 1.5V “AA” LR6/R6 batteries with correct polarity (+/-) as shown inside the battery compartment.
-
Install the battery cover and then tighten the screw on the battery cover.
-
Screw
-
Battery cover
-
2 x 1.5V “AA”
LR6/R6 batteries -
Power switch
-
Battery cover
-
Screw
-
2 x 1.5V “AA”
LR6/R6 batteries -
Power switch
How to play: (Refer to Diagram 4, 5 & 6)
-
Set the “Power Switch” on the controller and vehicle to ON position to match the frequency.
-
If the frequency of the vehicle and controller does not match, switch off both the vehicle and controller, then turn them on again.
-
Pull the trigger in the transmitter to drive the vehicle forward. Push the trigger in the transmitter to drive the vehicle backward.
-
Turn the steering knob on the transmitter to steer the vehicle to right or left.
-
If the vehicle does not run in a straight line, adjust the wheel alignment under the chassis.
-
Turn the switch off the controller and vehicle to OFF position when not in play.
-
Steering knob
-
Left
-
Right
-
Power Switch
-
backward
-
Stop
-
Forward
-
WHEEL ALIGNMENT
Performance Tips:
-
Do not drive the vehicle on grass, sand or go through water.
-
Do not drive the vehicle in windy or rainy weather.
-
Do not drive the vehicle into any hard object.
-
Keep fingers, hair and loose clothing away from the vehicle.
-
The operating range can be affected by a variety of factors:
a) Weak transmitter or vehicle batteries.
b) Interference from other items that emit radio frequency signals such as another R/C item on the same frequency, CB radios, cordless phones, high voltage transformers, etc. -
Outdoor usage is recommended in order to get optimal control range.
Battery use:
- Alkaline batteries are recommended.
- Only batteries of the same or equivalent type as recommended are to be used.
- Do not mix alkaline, standard or rechargeable batteries.
- Do not mix old and new batteries or different type of batteries.
- Non-rechargeable batteries are not to be charged.
- Rechargeable batteries are only to be charged under adult supervision.
- Rechargeable batteries are to be removed from the product before they are charged.
- Be sure to insert batteries with correct polarities and always follow the battery manufacturer’s instructions.
- Remove all batteries from the product when not in use for long periods of time.
- Exhausted batteries are to be removed from the product.
- The supply terminals are not to be short-circuited.
- Dispose of batteries properly. Do not dispose of batteries in fire – it may cause them to explode or leak causing injury or damage.
- Battery change must only be made by adult.
Cautions:
-
Do not attempt to disassemble the products.
-
Do not operate the vehicle with same frequency with other players in same location.
This will interfere and cause the vehicle to lose control. -
Make sure the batteries are installed with correct polarity (+/-) as shown inside the battery compartment.
-
Remove the package, take out all accessories and assemble the product before giving it to children to play.
FCC Label Compliance Statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions :
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Warning : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
RSS-210 Compliance Statement :
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference;
- This device must accept any interference, including interference that may cause undesired operation of the device.
Troubleshooting:
Problem | Cause | Correction |
---|---|---|
No Function | Low battery level |
Battery polarities are reversed
The wheels are obstructed by foreign objects| Replace with new batteries
Insert the batteries with correct polarities as shown on the battery
compartment
Remove foreign objects on the vehicle / wheels
Drive Slow /
Poor Turning Signal| Low battery level
The wheels are obstructed by foreign objects| Replace with new batteries
Remove foreign objects on the vehicle / wheels
Poor distance control| Low battery level
Strong interference of surroundings| Replace with new batteries
Move to a better location far playing
Environmental notes:
The whole product also does not belong to household waste at the end of the
product life.
You can return it at collodion points for the recycling of electronic and
electronical instruments.
The symbol on the item, instruction manual, hangtag or packing is showing this
clearly.
Materials should be recycled according to their respective markings.
Recycling of old devices or other re-use of materials contained therein
represents an important contribution to environmental protection.
Please ask at your local community for the correct collection point.
Please retain this sheet and address for -future use, as they contain important information.
Disposal of batteries
Batteries should not be disposed of in the household waste. As the consumer
you are legally obliged to return batteries containing harmful substances and
all other used batteries.
You can hand in your old batteries at public collection points in your area or
wherever batteries are sold.
You will find these chemical abbreviations along with a crossed-out refuse bin on batteries containing harmful substances:
Pb = Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury
CE Declaration
Hereby, MAY CHEONG GROUP FRANCE S.A.S., declares that this equipment is in compliance with the essential requirements and other relevant provisions of directive 2014/53/EU.
Frequency: 2.4GHz
Transmitting frequency band: 2.4-2.4835GHz
Max allowed transmitting power: <10mW
The declaration of conformity may be consult at:
MAY CHEONG GROUP FRANCE SAS.;
Parc Ariene – Le Vénus, 2 rue Hélène Boucher, 78280 Guyancourt, France.
The full text of the EU declaration of conformity is available at the
following internet address:
maycheonggroup.com.hk/web/declaration-of-
conformity
www.maisto.com MADE IN CHINA
Size: 742.5mm(W) x 420mm(H)
Color: 1C (Black)
MAY CHEONG TOY PRODUCTS FTY. LTD. | DIECUT |
---|---|
Job Item: Q0349_21R0A2 ins MU1 | Finished by: Qiang |
2022/09/02 | Test No.: |
Item No.: 81550 1:24 MaistoTech RC | Check by: |
Material:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>