RAM MOUNTS RPR-INS-B-460 RAM Tough Strap Handlebar Ball Base Instruction Manual
- June 12, 2024
- RAM MOUNTS
Table of Contents
RAM MOUNTS RPR-INS-B-460 RAM Tough Strap Handlebar Ball Base
Product Information
The product is a mounting system designed to securely attach electronic devices to handlebars or rails of various diameters. It consists of several parts, including straps (B or C), rubber strips (D or E), and other components. The straps and rubber strips are available in different sizes to accommodate different rail diameters. The short strap (B) is suitable for rail diameters between 0.875 and 1 inch, while the long strap (C) is suitable for rail diameters between 1.125 and 1.38 inches. The rubber strip can be either short (D) or long (E), with the long strip being cut to fit as needed.
The product is manufactured by National Products, Inc, and should not be installed near or over an airbag deployment area or in a location that obstructs the driver’s vision or interferes with vehicle operation. National Products, Inc does not assume responsibility or liability for any personal injury, death, or property damage resulting from improper installation.
Product Usage Instructions
- Choose the appropriate strap (B or C) and rubber strip (D or E) based on the diameter of your handlebar or rail. Refer to the provided chart to determine the correct sizes.
- Adhere the selected rubber strip (D or E) to the chosen strap (B or C). Ensure a secure attachment.
- Follow the diagram provided to connect the remaining parts, including attaching the strap assembly (B or C with rubber strip) to the handlebar or rail.
- Ensure all connections are tight and secure before using the product.
For additional mounting options and more information, please visit rammount.com.
Note:
This document, including images, may not be reproduced partly or fully without
the expressed written consent of National Products, Inc.
Part Index
- not to scale
Diameters
Select the proper strap (B or C) and rubber strip (D or E) to fit the following rail diameters:
| Diameter | Strap | Rubber Strip |
|---|
0.875″ – 1″
|
Short (B)
|
Short (D)
1” – 1.125”| Short (B)| Long (E) – Cut to Fit
1.125” – 1.25”| Long (C)| Short D)
1.25” – 1.38”| Long (C)| Long (E)
Installation
- Adhere (D or E) Rubber Strip to (B or C) Strap. See the chart above to determine the correct sizes for your handlebar.
- Connect the remaining parts as outlined in the diagram below.
Safety Precaution
Do not install this product near or over an airbag deployment area or in a location that obstructs the driver’s vision or interferes with vehicle operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death, or property damage.
To see more mounting options, visit RamMount.com.
This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.