CRYSTORAMA 1005-CH-CL-MWP Traditional Crystal Five Light Chandelier Instruction Manual
- June 12, 2024
- CRYSTORAMA
Table of Contents
CRYSTORAMA 1005-CH-CL-MWP Traditional Crystal Five Light Chandelier
Product Information
- Model Number: 1005-CH-CL-MWP
- Product Name: Crystal Chandelier
- Brand: Lighting the Way
- Warranty: Not specified
Specifications
- Crystal Sets: A, B, C, D, E, F, G
- Top Bobeche: Alternate A & B
- Bottom Bobeche: Ex5
- Electrical Rating: Dry rated
- Bulb Type: Candelabra Base Bulb
- Recommended Wattage: 40 Watts
- Maximum Wattage: 60 Watts
Warnings
- All electrical components must be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes.
- Use LED bulbs for extended use.
- This product can expose you to Lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm. For more information, visit www.p65warnings.ca.gov.
Parts included
- (2) Wire Connector
- (1) Mounting Bar
- (1) Lock Washer
- (1) Hex Nut
- (1) Nipple
- (1) Canopy (W5xH1) – XSN1005CHCAN5IN
- (1) Collar Ring
- (1) Collar Loop
- (1) Chain (4mmx72) – XSN1005CHCHA4MM
- (1) Center Column Kit Loop
- (1) Finial – XSN1005CHFIN
HOW TO INSTALL:
Place the fixture parts on a soft cloth-covered platform before installation of fixture.
- Screw the Center column kit onto the distributor box.
- Place the bottom bowl, check ring, bottom bobeche, check ring, in that order, over the bottom distributor box. Secure with the finial.
- To install the glass arms, slightly loosen each screw on the top plate over the distributor box. Pull a female plug through a hole in the plate. Connect the male plug at the end of the arm with the female plug that was just pulled. Push the end of the arm with the metal tab through the hole until stopped by the metal tab(this should also push the wires and plugs back inside the metal plate). Twist the metal tab counter-clock wise until both inserts lock onto the loose screws. Tighten the screw securing the arm in place. Repeat for all arms.
- Insert the scrolls onto the holder and Put the bobeche over the socket.
- Attach the mounting bar onto the outlet box.
- Decide the desired hanging height and adjust the chain to the correct length.
- Raise the fixture up and do the wire connection. Attach the canopy over the mounting bar and secure with collar ring.
- Dress the crystals as illustrated.
Crystal Sets
- 5 Sets. (5)14mm + AS9-1.5″
- 5 Sets. (3)14mm + AS9-1.5″
- 5 Sets. (1)Ring + (1)Square + (2)14mm + AS9-2″
- 10 Sets. (13) 14mm
- 25 Sets. (1)14mm + AS9-2″
- 1 Piece. (3)14mm + AS8-40mm Ball
- 5 Sets. (1)Ring + (1)14mm + AS9-2.5″
DETAILED ILLUSTRATION
Part Number
- A.(2)-Wire Connector
- B. (1)-Mounting Bar
- C. (1)-Lock Washer
- D. (1)-Hex Nut
- E. (1)-Nipple
- F.(1)-Canopy (W5″xH1″)F.(1)-Canopy (W5″xH1″)-XSN1005CHCAN5IN
- G. (1)-Collar Ring
- H. (1)-Collar Loop
- I. (1)-Chain(4mmx72″)-XSN1005CHCHA4MM
- J. (1)-Center Column Kit Loop
- K. (1)-Center Column Kit
- Top Bobeche;Ø6″,10pin,14mm center hole
- XSN1005CHBOB10PN
- Glass Vase x 2pieces ;H5″
- L. (5)-PVC Candle Sleeve
- M. (5)-Bobeche ; Ø4″,4pin,24mm center hole
- XSN1005CHBOB4PN
- N. (5)-8″Arms-XSN500CHARM8INKD
- O. (5)-6″Scrolls-XSN1005CHSCR
- P. (5)-Female Plug
- Q. (5)-Holder
- R. (1)-Distributor Box
- S. (1)-Bottom Bowl ; Ø6″,no pin,13mm center hole.
- T. (2)-Check Ring ; Ø1 3/8″
- U. (1)-Bottom Bobeche; Ø4″,5 pin,24mm center hole
- – XSN1005CHBOB5PN
- V. (1)-Finial-XSN1005CHFIN
Note: Place the fixture parts on a soft cloth-covered platform before installation of the fixture.
WARING: This product can expose you to Lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm.For more information go to www.p65warnings.ca.gov
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>