SpeedyBee Master 5 V2 Frame Installation Guide
- October 30, 2023
- SpeedyBee
Table of Contents
SpeedyBee Master 5 V2 Frame
Installation Instruction
CNC camera mount and camera side plate installation
Antenna Installation Sequence
insert the O-ring into the antenna to secure it on the TPU antenna base.
Install the multi-function antenna base
Choose a suitable VTX antenna base
Install the plate on one side and GPS base
Install the T-shaped antenna
(* Note : pictures for assembly reference only. Frame doesn’t include antenna)
Choose a suitable VTX antenna base
Install arms and anti-vibration module
(Complete the installation of 4 arms in turn)
Install middle plate
Combination with completed parts 1 and 2
Install rear top plate and battery anti-slip silicone
Arm foot mount installation
- Install the 3D printed foot mount to arms
- Use screw of proper length based on the motor installation
(Notice: default screws are M38mm, M3*10mm)
O3 Air Unit Installation Method
The 4 original screws at the bottom of the O3 Air Unit need to be removed
Recommend installing ESC in reverse horizontally 180°
*Note (After the ESC is installed reversely, remember to redefine the correct position and direction of motors 1-4.)
It is recommended to keep the power cable of ESC to be about 100mm.
Please refer to the used battery for actual length.
Inner motor wire recommended length: 110mm
Outer motor wire recommended length: 93mm
Scale
Scan the QR code to get the installation guide.
We recommend you scan it through the SpeedyBee App for detailed instructions.
-
SpeedyBee APP
-
Installation Guidance
-
Facebook QR Code
