BISSELL 2982F Pet Stain Eraser PowerBrush User Guide
- June 4, 2024
- Bissell
Table of Contents
BISSELL 2982F Pet Stain Eraser PowerBrush
Charging
- Upon removing your machine from the box, insert the charger
- For a maximum run time, charge the machine for 4.5 hours prior to use
- Note: It could take up to 2 hours for the machine to go from 1 to 2 battery lights while charging
|
Battery Light Indication
|
Battery Charge Percentage
---|---|---
|
No Battery Lights
|
Machine is powered off/ Machine is fully charged if plugged in
|
One Battery Light Breathing
|
1%-14% charged
|
One Battery Light Solid, One Breathing Battery Light
|
15%-69% charged
|
Two Solid Battery Lights, One Breathing Battery Light
|
70%-90% charged
|
Three Solid Battery Lights
|
Fully Charged
|
Battery Light Indication
|
Battery Charge Percentage
---|---|---
|
One Battery Light Blinking
|
Battery Below 15% > Plug into Charge
Formula Tank
- Open Formula Tank Cap and fill with Formula to the Formula dot
- Close Formula Tank Cap until it clicks and is securely closed
Cleaning
- Turn Machine on
- Brush Roll will automatically start spinning, to turn Brush Roll off hit the Brush Roll button
- Brush Roll will automatically start spinning, to turn Brush Roll off hit the Brush Roll button
- Spray Formula in the desired area using the Spray Button
- Scrub the area with the rotating PowerBrush
- Keep the nose of the machine flat on the surface
- Keep the nose of the machine flat on the surface
- For best suction, tilt the machine slightly forward and pull backward while firmly pressing the suction channel to the cleaning area
- Make sure to empy the Dirty Tank when it reaches the MAX FULL line
- For instructions on Emptying the Dirty Water Tank > Go to After Cleaning Care
- For instructions on Emptying the Dirty Water Tank > Go to After Cleaning Care
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>