allen roth FSI 1802 Drapery Rod Instruction Manual
- June 12, 2024
- Allen+Roth
Table of Contents
allen roth FSI 1802 Drapery Rod
Thank you for purchasing this alien + roth product. We’ve created these easy-
to-follow instructions to ensure you spend your lime enjoying the product
instead of putting ii together. But, if you need more information than what is
provided here, please visit Lowes.com, search the item number and refer to the
Guides & Documents lab on the product’s page.
If the item is no longer for sale, or if you have any questions or problems,
please call our customer service department at
866-439-9800, 8 a.m. – 8 p.m., EST,
Monday – Sunday. You could also contact us at
partsplus@lowes.com.
TROUBLESHOOTING
Problem | Possible Cause | Corrective Action |
---|---|---|
Drapery rod not level. | Drapery hooks not installed correctly. | Make sure to |
use level (not included) during installation.
Drapery rod hook is loose.| Drapery hooks not anchored correctly.| Attach
drapery hooks to wall studs if possible. Use anchors and screws supplied if
you can’t attach to stud.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 30 minutes
TOOLS REQUIRED (NOT INCLUDED)
FEELING CONFIDENT? START YOUR NEXT PROJECT
Visit lowes.com for more information
CARE AND MAINTENANCE
- Clean with a soft cloth.
- Do not use abrasive cleaning agents, solvents or polishes as they may damage the finish.
PACKAGE CONTENTS
HARDWARE CONTENTS
INSTALLATION OVERVIEW
-
Using bracket as a guide, adjust to desired height and mark location on wall for mounting screws.
-
Remove bracket from wall. Drill pilot hole using 3/16 in. bit (not included) and insert wall anchors.
NOTE Anchors are not needed for all installation types. -
Attach bracket to wall using screws provided. Next adjust the bracket distance out from the wall as desired and tighten with screws provided.
NOTE Repeat steps 1 to 3 for additional brackets. Use level (not included) if necessary. -
Extend telescopic rod slightly. Remove finial from smaller diameter rod section.
-
Slide additional rod over smaller diameter rod.
NOTE At this point you should have a complete telescopic rod with 2 large diameter rods connected with 1 smaller diameter rod section in the middle.
NOTE Add drapery (sold separately), extend rod to desired length and hang ready rod in brackets. -
Reattach finial and tighten set screws on brackets to lock rod in place.
ALLEN+ROTH and logo design are trademarks or registered trademarks of LF, LLC. All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>