ESR 2C540B Wireless Car Charger with CryoBoost User Manual

June 12, 2024
ESR

ESR-LOGO

ESR 2C540B Wireless Car Charger with CryoBoost

ESR-2C540B-Wireless-Car-Charger-with-CryoBoost-PRODUCT-
IMAGE

ESR-2C540B-Wireless-Car-Charger-with-CryoBoost-03

  1. HaloLock*” charging pad
  2. CryoBoost™ status light & vent
  3. USB-C port
  4. Air vent mount
  5. CrvoBoost™ intake

Status Light GuideESR-2C540B-Wireless-Car-Charger-with-
CryoBoost-05

If an error is detected•

  1. Ensure that your phone supports wireless charging and that there are no credit cards, stands, or other attachments on the back that will interfere with charging.
  2. After checking the above, unplug and plug in the charging cable again to resume normal charging.

Important Reminders

  1. This charger will only attach to a caseless iPhone with MagSafe, an official MagSafe case, ESk HaloLock case, or a standard case with a HaloLock Universal King. It may not attach to other magnetic cases. It will not attach to any other non-magnetic phones or cases.
  2. This charger supports an input of 9V-2A and outputs a maximum of 10W. The maximum output supported by iPhone is / oV
  3. For maximum charging speed, use included cable and an adapter compatible with OC (Quick Charge) 2.0/3.0 or PD (Power Delivery) fast charging.
  4. The charger must be connected to a power source to begin wireless charging.

ESR-2C540B-Wireless-Car-Charger-with-CryoBoost-01

ESR-2C540B-Wireless-Car-Charger-with-CryoBoost-02

Safety Warnings

  1. Do not expose the device to temperatures below 0°C 32 or above 60 C 140′.
  2. Do not expose the device to an open flame or submerge it in water as this will damage me device
  3. Always check for damage to the device, cables, or other accessories before using the device. If damaged. do not use the device.
  4. Do not attempt to disassemble or modify the device in any way, as it may cause serious damage and void the warranty.
  5. Do not expose the device to corrosive liquids, or high humidity as they will seriously damage the device and void the warranty.

FCC ID: 2APEW-2C540B
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator &your body.

Declaration of Conformity

This product is intended for use within Europe. Electronic Silk Road Corp. hereby declares that this product 2C540B is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU,2014/35/EU,2014/30/EU. The Declaration of Conformity for the 2C540B is available from www.esrgear.com

This symbol indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment.

ESR Wireless Car Charger with CryoBoost (HaloLock)
MODEL: 2C540B

Scan to watch a quick setup video

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals