CRYSTORAMA 1130-CH-CL-MWP Traditional Crystal Ten Light Chandelier Instruction Manual

CRYSTORAMA 1130-CH-CL-MWP Traditional Crystal Ten Light Chandelier

DIMENSION

Product Information

This product is a lighting fixture with model number #1130-CH-CL-MWP. It is manufactured by Crystorama and has a history of providing lighting solutions for sixty years. The fixture is designed with alternating A & D trim crystals, crystal sets, and a center column kit. It is damp rated and requires 10 candelabra base bulbs with a recommended wattage of 40 Watts (maximum 60 Watts). The use of LED bulbs is recommended for extended use. Please note that this product contains lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm.

Product Usage Instructions

1. Before installation, place the fixture parts on a soft cloth-covered platform.
2. Loosen each of the 6 arms slightly and install them onto the designated holes.
3. Repeat Step 2 for the 10 arms using the remaining holes.
4. Screw the center column kit onto the distributor box.
5. Place the bottom bowl, metal washer, bobeche, and metal washer in that order over the distributor box. Secure with the finial.
6. Attach the mounting bar onto the outlet box.
7. Decide the desired hanging height and adjust the chain to the correct length.
8. Raise the fixture up and make the wire connections. Attach the canopy over the mounting bar and secure with the collar ring.
9. Dress the crystals as illustrated.

Note: All electrical components must be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes. It is important to turn off the power before any electrical work.
If you have any concerns or need more information about this product, please visit www.crystorama.com or refer to the provided assembly instruction manual.

Warning: This product contains lead and can expose you to Lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm. For more information, please visit www.p65warnings.ca.gov.

ASSEMBLY INSTRUCTION

MODEL #1130-CH-CL-MWP

WARNING: All electrical components must beinstalled by a licensed electricianin accordance with the NationalElectric Code and the appropriatelocal electrical codes.

You will need 10- Candelabra Base Bulb40 Watts recommended 60 Watts Max.USE LED BULBS FOR EXTENDED USEAll electrical components must beinstalled by a licensed electricianin accordance with the NationalElectric Code and the appropriatelocal electrical codes.The fixture is Damp rated

HOW TO INSTALL: Place the fixture parts on a softcloth-covered platform beforeinstallation of fixture.

1. To install the 6″arms, slightly loosen each screw on the metal plate.
   • Pull a female plug through a hole in the upper metal plate.
   • Connect the male plug at the end of the upper arm with the female plug that was just pulled. Push the end of the arm with the metal tab through the hole until stopped by the metal tab (this should also push the wires and plugs back inside the metal plate).
   • Twist the metal tab counter-clock wise until both inserts lock onto the loose screws.
   • Tighten the screw securing the arm in place. Repeat for all 6″arms on every other hole.
2. Repeat Step 1 for the 10″arms using the remaining holes.
3. Screw the Center column kit onto the distributor box.
4. Place the bottom bowl, metal washer, bobeche and metal washer in that order, over the distributor box. Secure with the finial.
5. Attach the mounting bar onto the outlet box.
6. Decide the desired hanging height and adjust the chain to the correct length.
7. Raise the fixture up and do the wire connection. Attach the canopy over the mounting bar and secure with collar ring.
8. Dress the crystals as illustrated.

Crystal Sets

• A. 60 Sets. (1)14mm+AS9-2″
• B. 5 Sets. (1)Ring + (1)Square + (1)14mm+AS9-3″
• C. 5 Sets. (3)14mm+(1)Square+(3)14mm+AS9-3″
• D. 5 Sets. (24)14mm
• E. 10 Sets. (14)14mm
• F. 1 Piece. (3)14mm+AS8-40mm Ball

WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm.For more information go to www.p65warnings.ca.gov

Part Number

• A. (1)-Mounting hardware
  • Wire connector ×2.
  • Mounting bar x1.
  • Lock washer ×1.
  • Hex nut ×1.
  • Nipple ×1.
  • Screw ×2.
• B. (1)-Canopy (W5″xH1″)-XSN1130CHCAN5IN
• C. (1)-Collar Ring
• D. (1)-Collar Loop-XSN1130CHLOOP
• E. (1)-Chain (4mmx72″)-XSN1130CHCHA4MM
• F. (1)-Center Column Kit Loop
• G. (1)-Center Column Kit
  • Top Bowl ; Ø6″,10pin,13mm center hole.
  • XSN1130CHDIBOB10PN
  • Glass Vase; H6″
  • Top Bobeche ; Ø5″, 5pin,24mm center hole.
  • XSN1130CHBOB5PN
  • Glass Vase; H8″
  • Metal Cover ; H1.5″
• H. (5)-6″ Arms with holder-XSN529CHARM6INKD
• I. (11)-Bobeche; Ø4″, 4pin,24mm center hole.
  • XSN1135CHBOB4IN
• J. (5)-10″ Arms with holder-XSN503CHARM10INKD
• K. ( 10)-Male Plug
• L. (1)-Distributor box with female plug ; Ø5 1/2″ ; 11mm center hole.
• N. (2)-Metal washer
• M. (1)-Bottom bowl ; Ø6″, 6pin, 24mm center hole.
  • XSN1130CHDIBOB6IN
• O. (1)-Finial-XSN1130CHFIN
• P. (10)-PVC candle sleeve ; H4″

QR SCAN

Crystorama.com

References

• Crystorama Lighting
• p65warnings.ca.gov

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>