Ningbo Free Trade Zone Rising Sun Electrical RSW888T RSL Wireless Remote Control Instructions
- June 13, 2024
- Ningbo Free Trade Zone Rising Sun Electrical
Table of Contents
Ningbo Free Trade Zone Rising Sun Electrical RSW888T RSL Wireless Remote
Control
Product Information
The RSL wireless remote control, model RSW888T, is a compact and easy-to-use
device that allows you to control various functions wirelessly. It operates on
a single channel with a transmission frequency of 433.92 MHz, providing a
maximum range of 150ft in an
open area.
The remote control is equipped with two operating buttons. The upper button is used for turning ON the controlled device, while the down button is used for turning it OFF.
The remote control is powered by a round cell battery, specifically the CR2032 type. The battery compartment is located at the back of the remote control. Please ensure that the positive pole of the battery faces upward, as indicated by the “+” imprint on the battery. If the remote control’s range decreases noticeably or if the indicator lamp no longer lights up when a button is pushed, it is an indication that the battery needs to be replaced.
For safety purposes, please keep the battery away from children and do not
ingest it. Swallowing the battery can cause severe internal burns within just
2 hours and can even lead to death. If you suspect that a battery has been
swallowed or placed inside any
part of the body, seek immediate medical attention.
The RSL wireless remote control has an IP55 rating, which means it is protected against dust and low-pressure water jets.
Dimensions: Width – 78mm, Height – 32mm, Depth – 15mm
Usage Instructions
- To insert or replace the battery:
- Remove the battery compartment lid from the back of the remote control.
- Insert one round cell battery, CR2032 type, into the battery recess. Ensure that the positive pole of the battery faces upward (see the “+” imprint on the battery). Push the battery all the way into the recess.
- Close the battery compartment securely.
- To operate the remote control:
- Ensure that the battery is inserted correctly and the battery compartment is closed securely.
- To turn ON the controlled device, press the upper button on the remote control.
- To turn OFF the controlled device, press the down button on the remote control.
FCC Statement
This device complies with Part 15 of the FCC Rules. It operates under the following conditions: (1) it does not cause harmful interference, and (2) it accepts any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the responsible party for compliance could void the user’s authority to operate the equipment.
RSL wireless remote control
Model: RSW888T
Operating elements
- Upper button- ON
- Down button- OFF
Inserting/replacing battery
- Remove the battery compartment lid from the back of the remote control.
- Insert one round cell battery, type CR2032, into the battery recess. The positive pole should face upward (see the “+” imprint on the battery). Push the battery all the way into the battery recess.
- Close the battery compartment. The battery must be replaced when the remote control’s range decreases noticeably or when the indicator lamp no longer lights when a button is pushed.
Key functions
- Two control key: upper = ON/ down = OFF.
- Use the upper key to turn ON receiver.
- Use the down key to turn OFF receiver.
- The signal indicator lamp lights up each time a key is pressed.
- The battery indicator lamp will flash when the battery runs low.
- The remote control can control an unlimited number of compatible plugs.
Technical data
- Battery type …………………………CR2032
- Number of channels ……………..1 channel
- Transmission frequency…………433.92 MHz
- Transmission range ………………max. 150ft (in open area)
- IP code…………………………IP55
- Dimensions (W x H x D) ………..78 x 32x 15 mm
Notice
-
Do not ingest battery, Chemical Burn Hazard
This product contains a coin / button cell battery. If the coin / button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. -
Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
FCC statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This device generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this device does
cause harmful interference to radio or television reception, which can be
determined by turning the device off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>