PARKSIDE 409802 Cordless LED Work Light Instruction Manual

: June 12, 2024
: PARKSIDE

PARKSIDE 409802 Cordless LED Work Light Instruction Manual

CORDLESS LED WORKLIGHT 10W
PAS 2200 B1

CORDLESS LED WORKLIGHT 10W
Operation and safety notes

Figure A

Figure B-C-D

CORDLESS LED WORKLIGHT 10W
Operation and safety notes

Introduction

Congratulations!

With your purchase you have chosen a high-quality product. The operation and safety notes are an integral part of this product. They contain important information for safety, use and disposal. Familiarise yourself with all of the operation and safety notes before using the product. Use the product only as described and for the specific areas of application. Keep the operation and safety notes for future reference. Provide all of the documentation when passing the product on to third parties.

In the following, the Cordless LED Worklight 10W is referred to as the product.

Explanation of symbols

The following symbols and signal words are used in these operation and safety notes, on the product or on the packaging.

WARNING!

This signal symbol/word indicates a hazard with a high level of risk which, if not avoided, may result in death or serious injury.

CAUTION!

This signal symbol/word indicates a hazard with a low level of risk which, if not avoided, may result in minor or moderate injury.

NOTE!

This signal word warns of possible property damage or provides you with useful additional information regarding the use.

This symbol indicates the ON/OFF switch.

This symbol indicates direct current.

This symbol indicates the electrical power: watts.

These symbols indicate the electrical voltage (V) and the rated capacity of the battery (mAh).

This symbol indicates a USB-C port/ plug.

This symbol provides information regarding the maximum illuminance.

This symbol indicates the IP54 degree of protection (protection against splash water and dust in damaging quantities on all sides). Does not apply during charging via USB-C charging cable.

This symbol indicates protection class III. SELV: safety extra-low voltage.

These symbols inform you about the disposal of the packaging and the product.

Conformity declaration (see chapter „15. Conformity declaration”): Products that are marked with this symbol fulfil all applicable Community regulations of the European Economic Area.

Safety Intended use

The product is not intended for commercial use. Different use or a modification to the product are not deemed as intended use and may lead to risks, such as injuries and damage. The distributor assumes no liability for damage that results from improper use.

The product is intended for indoor and outdoor use.

The product is not suitable for household room lighting.

The product is intended as a mobile work lamp.

The product is suitable for use in harsh environments.

Use USB-C cable(s) only in dry and sheltered rooms.

Scope of delivery (Fig. A)

1x Spotlight housing 1 with carrying handle 1a and metal bracket 1b
1x Hand screw 2
1x Spacer ring 3
1x Washer 4
1x Stand base 5
1x USB-C cable 6
1x Operation and safety notes (without fig.)

Technical specifications

Type: Cordless LED Worklight 10W
IAN: 409802 – 2207
Tradix Item No.: 409802-22-A
Operating voltage: 3.7 V
Total output: max. 10W
Lithium-ion battery: 3.7 V , 2200 mAh,
Type: 18650, (not replaceable, hereinafter referred to as battery)
USB-C connection: 5V , 1A
Illuminant: 9 LEDs, each 0.9 W (white, not replaceable)
Projection surface: 9.4 x 9.4 cm (approx. 88 cm²)
Weight: 395 g
Dimensions: approx. 21.7 x 12 x 13.5 cm
Protection class: III/
Protection type: IP54
Production date: 11/2022
Warranty: 3 years

Safety information

WARNING!

Risk of injury and suffocation!

If children play with the product or the packaging, they may injure themselves or suffocate!

Do not let children play with the product or the packaging.
Supervise children who are close to the product.
Keep the product and the packaging out of the reach of children.

WARNING!

Risk of injury!

Not suitable for children under the age of 8! There is a risk of injury!

Children from the age of 8, as well as people with impaired physical, sensory or mental capabilities or with a lack of experience and knowledge, must be supervised when using the product and/or be instructed regarding the safe use of the product and understand the resulting dangers.
Children are not allowed to play with the product.
Maintenance and/or cleaning of the product is not allowed to be performed by children.

Observe national regulations!

Observe the applicable national requirements and regulations for the use and disposal of the product.

WARNING!

Risk of injury!

Do not use in an explosive environment! There is a risk of injury!

The product is not allowed to be used in an explosive (Ex) environment. The product is not approved for an environment, in which flammable liquids, gases or dust are present.

WARNING!

Risk of glaring!
Do not stare into the active light source!

Do not look directly into the light of the lamp and do not point the lamp at other people’s eyes. This can impair the eyesight.

The product may emit dangerous optical radiation. Do not look directly into the light of the lamp. This may be harmful to your eyes.

WARNING!

Risk of injury!
A defective product is not allowed to be used! There is a risk of injury!

Do not use the product in the case of malfunctions, damage or defects.
Significant danger can occur for the user in the case of improper repairs.
If you find a defect in the product, have the product checked and repaired if necessary before putting it back into operation.
The LEDs and the battery are not replaceable. If the LEDs or battery are defective, the product must be disposed of.

WARNING!

Risk of injury!

The product is not allowed to be manipulated! There is a risk of injury from electric shock!

The casing must not be opened and the product must not be manipulated/modified under any circumstances. Manipulations/modifications can cause danger to life from electric shock. Manipulations/ modifications are prohibited for approval reasons (CE).
The product must not be covered up during use.

Safety instructions regarding rechargeable batteries

WARNING!

Overheting and explosion hazard!

Keep the product away from heat sources and direct sunlight, the battery may explode if overheated. There is a risk of injury.
Do not operate the product in ist packaging! There is a risk of fire!

WARNING!

Risk of injury!

Wear gloves!
Do not touch leaked batteries with bare hands! There is a risk of injury!

Leaked or damaged batteries may cause acid burns if they come into contact with skin. Do not touch leaked batteries with bare hands; therefore, ensure that you wear appropriate protective gloves in such a case!

NOTE!

The product has a built-in rechargeable battery that cannot be replaced by the user. In order to avoid hazards, the battery may only be removed by the manufacturer or its service agent or by a similarly qualified individual.
When disposing of the product, please note that the product contains a rechargeable battery.

CAUTION!

Danger of overheating!
Remove packaging prior to use.

Start-up

Remove all packaging materials.
Check whether all parts are available and undamaged.
If this is not the case, notify the specified service address.

Legend

1 Spotlight housing
1a Carrying handle
1b Metal bracket
2 Hand screw
3 Spacer ring
4 Washer
5 Stand base
6 USB-C cable
6a USB-C plug
6b USB plug
7 Charge indicator
8 Cover
9 USB-C socket
10 ON/OFF switch
11 Locking screw

Mounting the stand base (Fig. B)

Mount the spotlight housing 1 with the metal bracket 1b as shown with the hand screw 2 , spacer ring 3 and washer 4 on the stand base 5 , see Fig. B.
Turn the hand screw 2 hand-tight closed.

NOTE!

The product must not be mounted with the metal bracket 1b e.g. on a wall.

Charging the battery (Fig. C)

NOTE!

The battery must be charged for 12 hours before the first use.
The battery must be charged as soon as the LEDs light up less brightly and the charging indicator 7 lights up red.

WARNING!

Risk of injury from electric shock!

Only charge the product in interior spaces.
If the product has become wet, you must dry the product completely with a dry cloth before charging. There is a risk of short circuit.
The product can be operated during the charging process. During the charging process, Protection Type IP54 no longer exists.

NOTE!

The battery is fitted with an automatic switch-off device. This switches off the charging process with a 100 % charge, so that the battery cannot be overcharged.

Connect the product to an appropriate device using the micro-USB-C cable 6 . You can also charge the battery e.g. using a power supply unit with a USB-C port, see Fig. C. Please observe the technical data.

The product can only be connected to a control device with a SELV output and a maximum working peak output voltage (Uout) of 5 V .

The product is equipped with a charge indicator 7 . The following states of charge are displayed:

green: fully charged
orange: ready for use
red: low charge, charging is required

Open the cover 8 on the back of the spotlight housing 1 , see Fig. C.
Insert the USB-C plug 6a into the USB-C socket 9 .
Insert the USB-C plug 6b into the charging device.
When charging is complete, remove the USB-C plug 6a from the USB-C- socket 9 .
Close the cover 8 .

The product is now ready to use.

NOTE!

The product should be recharged once a month if it is not used for a long period of time. If the product has not been charged for a long period of time (approx. 2 months), the battery will be in the idle state. Then the product should be charged and discharged several times to reactivate the battery.

Carrying the product

Only carry the product using the designated carrying handle 1a.

NOTE!

The product is not allowed to be 1a hung up on the carrying handle.

Setting up the product

Set up the product in an appropriate place.

NOTE!

The surface should be even, so that the product cannot fall over. The place should have sufficient free space around the product.

Protect sensitive surfaces by placing a protective blanket underneath.

Switching the product on/off

To switch on/off, press the ON/OFF button 10 , see Fig. C. A clicking sound can be heard when pressing the button.

Changing the light alignment

By loosening both of the locking screws 11 on the side of the spotlight unit 1 , change the light alignment vertically as shown, see Fig. D a). After adjustment, reclose the locking screws 11 hand-tight.
You can rotate the spotlight housing 1 in the horizontal alignment. Loosen the hand screw 2 and rotate the spotlight housing 1 in the desired direction, see Fig. D b). After adjustment, rotate the hand screws 2 hand-tight again.

CAUTION!

Risk of injury!

Watch your fingers when adjusting the product. You could possibly trap them.

Cleaning and care instructions

CAUTION!

Risk of injury!

Before cleaning, you must disconnect the USB-C cable 6 from the charging device (e.g. power supply unit) and the product and switch off the product. There is a risk of electric shock!

only clean with a dry cloth
do not use any strong detergents and/or chemicals
do not immerse in water
store in a cool, dry place and protected from UV light

Conformity declaration

This device complies with the fundamental requirements and other relevant regulations of the European Electromagnetic Compatibility Directive 2014/30/EU and the RoHS Directive 2011/65/EU. The complete original conformity declaration is available from the importer.

Disposal

Disposal of the packaging

The packaging and operating instructions are made of 100 % environmentally friendly materials, which you may dispose of at local recycling centres.

Disposal of the product

The product may not be disposed of with normal household waste. For information on disposal options for the product, please contact your local council/ municipality or your Kaufland shop.

Disposal of the battery / rechargeable battery

Defective or used rechargeable batteries have to be recycled in accordance with Directive 2006/66/EC and ist amendments.
Batteries and disposable batteries are not permitted to be disposed of with household waste. They contain harmful heavy metals. Marking: Pb (= lead), Hg (= mercury), Cd (= cadmium). You are legally obligated to return used batteries and rechargeable batteries. After use, you can either return batteries to our point of sale or in the direct vicinity (e.g. with a retailer or in municipal collection centres) free of charge. Batteries and rechargeable batteries are marked with a crossed-out waste bin.
Rechargeable batteries must only be disposed of when discharged. Discharge the battery by leaving the product switched on until it no longer lights up.

Warranty

Dear customer, the warranty on this product is 3 years from the purchase date. In the event of defects in this product, you are entitled to exercise your statutory rights against the seller of the product. These statutory rights are not limited by our warranty described in the following.

Warranty conditions

The warranty begins on the date of purchase. Please keep the original receipt. This document is required as verification of the purchase.

If a material or manufacturing defect arises within three years from the purchase date of this product, the product will be repaired or replaced, as per our choice, at no charge to you. This warranty service requires the submission of the purchase receipt and the defective product within the three- year period and a short written description of the defect and when it arose.

If the defect is covered by our warranty, the repaired or a new product will be returned to you. The warranty period does not restart with the repair or replacement of the product.

Guarantee period and statutory claims for defects

The guarantee period will not be extended by the warranty. This also applies to replaced and repaired parts. Damage and defects which may possibly already exist upon purchase must be reported immediately after unpacking. After the guarantee period has expired, required repairs shall be subject to a charge.

Scope of guarantee

The device has been carefully produced under strict quality guidelines and conscientiously inspected prior to delivery. The guarantee service applies to material or manufacturing faults. This guarantee does not extend to product parts, which are exposed to normal wear and tear and can therefore be regarded as wearing parts or to damage to fragile parts, e.g. switches or which are made of glass.

This guarantee shall lapse, if the product is damages, not used properly or maintained properly. For proper use of the product, all of the instructions in the operating instructions must be precisely complied with. Purposes and actions, which are dissuaded from or warned about in the operating instructions must be avoided.

The product is only intended for private and not commercial use. In the case of abusive and improper handling, use of force and with interventions, which are not performed by our authorised service branch, the guarantee shall lapse.

Processing in the case of a guarantee claim

To ensure quick processing of your concern, please follow the instructions below:

Please have the till receipt and article number available (IAN) 409802 – 2207 as proof of the purchase.
You can find the article number on the rating plate on the product, as an engraving on the product, the title place of your instructions or the sticker on the back or underside of the product.
If malfunctions or other defects occur, first contact the service department below by telephone or e-mail.
You can then send a product that has been recorded as being defective, including the proof of purchase (till receipt) and stating what the defect is and when it occurred, postage-free to the service address provided to you.

On www.kaufland.com/manual you can download these and many other manuals

QR Code 2 With this QR code, you can directly reach the Kaufland Service website (www.kaufland.com/manual). Click on the corresponding country to access the national overview of our manuals. By entering the item number (IAN) 409802 – 2207 you can open your user manual.