AKICON 96118 Copper One Handle Widespread Kitchen Bar Instructions

Table of Contents

AKICON-96118-Copper-One-Handle-Widespread-Kitchen-Bar-
product

Handle Removal Maintenance

Valve Cartridge Removal Maintenance

Cleaning Instructions

AKICON-96118-Copper-One-Handle-Widespread-Kitchen-Bar-
fig-1

After you open this package, please check to ensure that all of the following items are included.

AKICON-96118-Copper-One-Handle-Widespread-Kitchen-Bar-
fig-4

IMPORTANT NOTICES

For easy installation, please read all the instruction completely before beginning.
Before installing this product, make sure that water line trash is cleared to avoid blockage.

YOU MAY NEED

AKICON-96118-Copper-One-Handle-Widespread-Kitchen-Bar-
fig-5

AKICON-96118-Copper-One-Handle-Widespread-Kitchen-Bar-
fig-6

Remove any debris from valve outlets. Turning off the water supply valves. This is usually found near the water meter. If you are replacing an existing faucet, remove the faucet from the sink and clean the sink surface thoroughly.
Install without Deck Plate. Make sure the O-RING is placed onto the bottom of Base Ring. Install faucet through hole in sink. From underside sink, attach mounting assembly Position faucet on sink properly and tighten Mounting Nut.
Install with deck plate. Place a bead of plumber’s putty between faucet and sink. Place deck plate over the three holes of sink. Make sure the washer is placed onto the bottom of base ring. Install faucet through deck plate. From underside sink, put plastic washer and mounting nut. Position faucet on sink properly and tighten mounting nut.
If necessary, tighten screws using a adjustable wrench until the faucet is firmly connected to the sink.
Connect hot and cold water supply lines to the Water Supply Valves.
Open the valve, then turn the handle according to the sign of C and H on the handle to regulate the temperature of the water. (C=Cold,H=Hot)
Swing Spout

Faucet Start Up

After installation is complete, remove aerator and rotate handle to the closed position.
Turn on the water supply valves, and check all connections for a leak. Turn on your faucet and allow both hot and cold water to run at least one minute each. Replace Aerator.

Handle Removal Maintenance

Turn off water and relieve pressure! Detach handle button using a small flathead screwdriver, unscrew set screw using Allen Wrench and take off handle.

Valve Cartridge Removal Maintenance

Remove handles. Unscrew Dome Cap counter clockwise by hand. Unscrew Retaining Nut using adjustable wrench, take out cartridge assembly and inspect. Replace parts as necessary. Reassemble parts by reversing steps.

CAUTION: Maintenance

Replacement parts may be available at the store where you purchased your faucet.
Always turn off water and relieve pressure before working on your faucet.

NOTES: Cleaning Instructions

To keep the faucet clean, you should clean the faucet frequently and regularly.
Clean the faucet with clear water or mild liquid, rinse the faucet with clear water and then dry the faucet with soft cotton cloths.
Do not use any abrasive cleansers, cloths, or paper towel.
Do not use any acid or abrasive detergent.