CRYSTORAMA 2263-PN Jennings Three Light Ceiling Mount Instruction Manual
- October 30, 2023
- CRYSTORAMA
Table of Contents
CRYSTORAMA 2263-PN Jennings Three Light Ceiling Mount
Product Information
The Crystorama lighting fixture model #2263-PN is a dry-rated fixture that has been lighting the way for sixty years. The fixture comes with all the necessary parts and hardware for assembly, including mounting hardware, ceiling pan, metal frame, fabric shade, hex nut, nipple, glass diffuser, plastic washer, metal washer, cap, and bottom finial. The fixture requires three medium base bulbs, with a recommended wattage of 40 watts and a maximum wattage of 60 watts. LED bulbs are recommended for extended use.
It is important to note that all electrical components must be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes. Additionally, the product can expose you to lead which is known to the state of California to cause cancer and/or birth defects or reproductive harm.
Product Usage Instructions
- Turn off power before installing or replacing any electrical components.
- Thread the mounting screws into the matching holes in the mounting bar and secure the mounting bar to the outlet box with outlet box screws.
- Connect the fixture wires to the supply wires in the outlet box.
- Raise the ceiling pan to allow for mounting.
- To replace a bulb, remove the bottom finial and diffuser and replace the previous bulb with a new one.
By following these usage instructions, you can safely install and use the Crystorama lighting fixture in your home or office space.
MODEL#2263-PN
WARNING
- Electrical Danger
- Turn Power off
- All electrical components must be installed by a licensed electrician in accordance with the National Electric Code and the appropriate local electrical codes.
- You will need 3-Medium Base Bulb 40 Watts Recommended 60 Watts Max. USE LED BULBS FOR EXTENDED USE This fixture is Dry rated
How to install
- Thread the mounting screws into the matching holes in the mounting bar. Secure the mounting bar to outlet box with the outlet box screws.
- Connect fixture wires to supply wires in outlet box.
- Raise the ceiling pan allowing for the mounting screws to protrude through key slots on the ceiling pan. Rotate the ceiling pan clockwise until the mounting screws are in the narrow parts of the key slot then tighten the screws with a screw driver.
- Install the bulb(not included) into the socket.
- Thread the nipple onto the coupling and adjust the length of nipple to fit with the glass. Tighten it with hex nut.
- Slide the glass diffuser, the plastic washer and the metal washer over the nipple, then secure with the hex nut.
- Slide the cap over the nipple, then secure with the bottom finial.
HOW TO REPLACE BULB
REMOVE BOTTOM FINIAL AND DIFFUSER TO REPLACE PREVIOUS BULB W / NEW BULB.
WARNING: This product can expose you to Lead which is known to the state of California to cause cancer and/or birth defects or reproductive harm. For more information go to www.P65Warnings.ca.gov
Part Number
- A. (1)-Mounting hardware
- B. (1)-Ceiling pan
- C. (1)-Metal frame
- D. (1)-Fabric shade W15-3/8’’xH7-1/4’’ #XRF2263SHA15.375IN E. (2)-Hex nut
- F. (1)-Nipple
- G. (1)-Glass diffuser #XRF2263DIF15.75IN H. (1)-Plastic washer
- I. (1)-Metal washer
- J. (1)-Cap #XRF2263PNCAP K. (1)-Bottom finial #XRF2263PNFIN