MECHANICAL TRANSPLANTER 3 Point Hitch for JP-3 Push Seeder Instruction Manual

October 30, 2023
MECHANICAL TRANSPLANTER

MECHANICAL TRANSPLANTER 3 Point Hitch for JP-3 Push Seeder

For JH3, JH6 , JH6W
(for Jang Seeder Models JP-3, JP-6, JP6W)

For video instructions, please visit www.mechanicaltransplanter.com
Link is located on the “Video” tab.

INSTRUCTION

  1. On the seeder, remover bolts that attach the handle to the seeder frame. Replace with the 8 x 35mm bolts supplied, threading them from the inside of the frame to the outside as shown.MECHANICAL TRANSPLANTER-3-Point-Hitch-for-JP-3-Push-Seeder-1
  2. Slide on a washer and tighten on a nut. Slide on a second washer. Repeat on the other side of unit.
  3. Stretch fra-me over bolts. Insert bushing followed by washer and secure with a nut.MECHANICAL TRANSPLANTER-3-Point-Hitch-for-JP-3-Push-Seeder-2
  4. Lay outside arms and cross pieces as shown in photo. ** The L-bracket on the cross piece must face backward toward the back of the side arms. The cross piece dimensions are as follows:
    • A) 3-row is 16″ long
    • B) 6-row is 27″ long
    • C) 6W-row is 40″ long.MECHANICAL TRANSPLANTER-3-Point-Hitch-for-JP-3-Push-Seeder-3
  5. Use four 5/16 x 1″ bolts and four lock washers,along with two flat washers for over the two center slots. Thread bolts into the side arm holes and tighten.MECHANICAL TRANSPLANTER-3-Point-Hitch-for-JP-3-Push-Seeder-4
  6. Take a 3/8 x 1 -1/2 bolt and slide a 3/8″ washer,then a 7 /16″ long steel bushing onto the bolt. Now place it on the front hole of the side arm so that the bolt is sticking out the inside of the side arm.
    Place another 3/8″ washer on the bolt. Slide the lift arm over the bolt. The round L-bracket must go under inside of side arm. Now tighten with 3/8″ lock nut. Repeat above assembly on the other sidearm.MECHANICAL TRANSPLANTER-3
-Point-Hitch-for-JP-3-Push-Seeder-5For JP3,JP6
    Center the 3-Point hitch on pads of lifting brackets. Use two U-bolts and four flange nuts to secure 3- point on pads.

For the JP6W
Use 8 U-bolts, 16 flange nuts to fasten set back bracket to the 3- point hitch. * Note: JP6W may be centered or offset on toolbar.
Use four remaining U-bolts to fasten tool bar to set back bracket.
Center the 3-Point hitch on pads of lifting brackets. Use two U-bolts and four flange nuts to secure 3- point on pads.

MECHANICAL TRANSPLANTER-3-Point-Hitch-for-JP-3-Push-
Seeder-7

Multiple seeders may also be assembled on a longer tool bar to plant separate beds at a time

Distributed by: MECHANICAL TRANSPLANTER CO.
1150 Central Ave, Holland, Michigan 49423
P= (616)-396-8738 F= (616)396-3619
Website www.mechanicaltransplanter.com
E-mail mtc@mechanicaltransplanter.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals