VISUAL COMFORT CHC4163 Cynara Large Flush Mount Instruction Manual
- October 30, 2023
- VISUAL COMFORT
Table of Contents
- VISUAL COMFORT CHC4163 Cynara Large Flush Mount Instruction Manual
- ASSEMBLY INSTRUCTIONS
- Cynara Large Flush Mount
- NOTICE:
- TOOLS REQUIRED (NOT INCLUDED):
- ASSEMBLY INSTRUCTIONS
- Cynara Large Flush Mount
- NOTICE:
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
VISUAL COMFORT CHC4163 Cynara Large Flush Mount Instruction Manual
ASSEMBLY INSTRUCTIONS
Cynara Large Flush Mount
Item # CHC4163
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect item and
contents carefully. If any damage or defect is found, do not install. Retain
all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
Phillips Screwdriver Slotted Screwdrive
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from canopy (D) by unscrewing.
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
-
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (A). CAUTION: Do not reverse the hot and neutral connections.
-
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install mounting plate (B) to junction box and secure with mounting screws (C).
-
Thread canopy (D) to mounting plate (B).
-
Thread fixture frame to canopy (D).
NOTE: Do not overtighten otherwise fixture frame could become damaged. -
Install light bulb into the socket.
-
Install bottom frame (N) to fixture frame and secure with screws (O).
ASSEMBLY INSTRUCTIONS
Cynara Large Flush Mount
Item # CHC4163
NOTICE:
This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
12. Install decorative part (E through M) by securing to fixture frame as
shown in diagram 2.
Note: : Start from bottom (layer 1) and work your to the top (layer 9).Care
Instructions: Clean only with a soft dry cloth or feather duster. Do
Not use abrasive or chemical agents.