TOO CM-303B-1200W Grill Crepe Maker Instruction Manual

TOO CM-303B-1200W Grill Crepe Maker

Product Information

The TOO CM-303B-1200W is a crepe maker designed for domestic use only. It has a voltage of 220-240V~50-60Hz and a power of 1200W. The crepe maker consists of several parts including an indicator light, housing, crepe plate, adjustable knob, wood spatula, and wood T shape.

Product Usage Instructions

1. Before using the crepe maker, read the instruction manual carefully and keep it for future reference.
2. The device is only intended for making crepes and should not be used for industrial purposes.
3. Before the first use, note that the device should be cleaned and the power cord should be wrapped around the cable winder on the bottom of the unit.
4. When making crepes, wait until the device has cooled down to avoid the risk of fire. Disconnect the unit from the power supply before cleaning to avoid electric shock.
5. After use, store the device in a dry and clean place.
6. If disposing of the crepe maker, do not throw it in your normal domestic waste. Instead, dispose of it through suitable collection systems or send it to the place where you purchased it for material recycling. Ensure environmentally-friendly disposal of packaging materials.

Read the instruction manual carefully before use!
Do NOT discard these instructions!

Please read the operating instructions carefully before use and keep them for future reference

Intended Use

The device is only suitable for the preparation of crepes as well as the use for domestic use. The industrial use of the device is prohibited.

Safety instructions for electrical equipment

• Make sure that the unit never comes into contact with water as long as it is connected to the power supply. Be particularly careful when using the appliance near sinks.
• Make sure that the power cord is never wet when the unit is in use. Make sure you never stumble over the cable.
• Disconnect the device from the power supply after use.
• Have defective power cables repaired by a technician or customer service to avoid damage. Instructions for the prevention of fire hazards:
• Ensure that the unit is at a minimum distance of 50 cm from the wall, curtains or other objects.
• Never place the unit near inflammable materials, such as walls or curtains, as the unit may burn.
• Never leave the appliance unattended when not in use.
  This appliance is only suitable for children under 8 years of age or persons with limited physical, sensory or psychological abilities, or without any experience or prior knowledge, if adequate supervision or detailed instructions on the use of the appliance by a responsible person are ensured. Children should be supervised to make sure they are not playing with the unit. Ensure that children under 8 do not perform any cleaning or maintenance work on the unit.

1. Please keep the appliance away from children.
2. In case of a defective power cord don’t accept the product from the manufacturer or the service center.
3. The unit is not suitable for use with a timer or a remote-control unit.
4. Attention! The device and surface can become very hot during use.
5. Cleaning and maintenance work must not be performed by children.

Technical specifications

Voltage: 220-240V~50-60Hz Power: 1200W

CM-303B-1200W Crepe Maker parts

1.  Indicator light;
2. Housing;
3. Crepe plate;
4. Adjustable knob;
5. Wood spatula;
6. Wood “T” shape

Before the first device use

• Remove the packing material from the unit.
• Wipe the baking tray with a damp cloth.
• Place the unit on a heat-resistant, flat surface.
• Place the unit so that it is secure and stable.
• Connect the device to the power supply. The control lamp lights up.
• Set the thermostat to MAX and allow the appliance to heat up for about 10 minutes.

Note:
During the first use of the appliance, smoke and odor can develop. This is normal and not dangerous. Ensure adequate ventilation, for example by opening the window.

• Reset the thermostat to “0” and remove the plug from the socket.
• Allow the unit to cool and wipe it again with a damp cloth. The device can now be used.

Crepes

1. Connect the device to the power supply. The control lamp lights up.

2. Set the thermostat to MAX and allow the appliance to heat up for about 10 minutes.

3. Add the dough to the baking surface.
   Note: To determine the correct amount of dough, add enough dough to the baking surface to cover 2/3. Make sure that the ground does not run down on the unit. If this is the case, add less dough to the baking surface next time.

4. Spread the dough with the dough spatula evenly on the baking surface. Note: Immerse the dough spatula after use in water. This allows the dough to be distributed better on the baking surface.

5. Between two crepes wait 45 seconds.
   Note: The indicated baking time serves only as a guideline. The actual baking time may vary.

6. Remove the crepe from the baking surface after approximately 45 seconds and place it on a plate.

7. Garnish the finished crepe to your taste.
   ATTENTION! Equipment Damage!

   • Never cover or garnish the crepe when it is still on the baking surface.
   • Do not cut the crepe when it is still on the back surface.
   • Never use metal objects to turn the crepe and to avoid damage to the appliance.

8. Repeat the above process to bake more crepes.

Cleaning and maintenance

Danger! Disconnect the unit from the power supply before each cleaning operation to avoid the risk of electric shock.
Attention! Always wait until the unit has cooled down to avoid the risk of fire-

Attention! Never immerse the appliance in water if you wish to clean it. Thus, irreparable damage can be avoided. • Wipe the back surface with a damp cloth. Remove stubborn device dirt with a mild detergent. The baking surface can be cleaned in the dishwasher. • Clean the dough divider and the pasta dispenser with a mild detergent solution. Rinse it with clean water and then dry it with a chimney.

Storage
Wrap the power cord around the cable winder on the bottom of the unit. Connect the device to the power supply. Store the unit in a dry and clean place.

device disposal

Do not dispose of the appliance in your normal domestic waste. This product is subject to the European Directive 2002/96/EC. Therefore, you should dispose of old equipment via suitable collection systems or send the device to the place where you purchased it. This will then feed the device to material recycling Ensure environmentally-friendly disposal of the packaging materials.

Maintenance and warranty

The warranty is 1 years from date of purchase. The unit has been carefully prepared and inspected before delivery. Please keep the purchase slip carefully. In case of warranty claim, please contact the Customer Center. The guarantee claim can be asserted in case of material and manufacturing defects. Normal wear and tear or damage to easily damaged parts such as buttons or battery are not covered by the warranty. The device is only suitable for private house use. The warranty claim shall be void in case of misuse, use of force or any other device modification. All legal rights are not restricted by this guarantee claim.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>