FOX Halo Illuminated Marker Pole Remote Control Instruction Manual

FOX Halo Illuminated Marker Pole Remote Control

Product Information: Illuminated Marker Poles

The Illuminated Marker Poles are a product of Fox International Group Ltd. The product is exclusively designed to work with the Halo Capsules and is not compatible with other existing Fox products. The product comes with a remote that contains an advanced transmitter device capable of long distances. The remote has been designed to have very low battery drain, and a new set of batteries will last for long periods. The product is weatherproof and has an IP rating of IPX5. The operating frequency of the product is 434MHz.

Product Usage Instructions

Fitting the Batteries

1. Using a cross head screwdriver, unscrew the two battery cover screws.
2. Pull the lower edge up and slide back to remove the battery cover.
3. Take care removing the batteries. Insert new batteries and ensure correct polarity.
4. DO NOT over tighten the battery compartment screws, excessive force will damage the screw threads.
5. Nasate kryt baterie a zasroubujte.

Operation

To operate the Illuminated Marker Poles, follow these steps:

1. Fit the batteries as per the instructions given above.
2. Press any button on the remote to activate the product.
3. When in registration mode, press the preferred button on the remote to register it with the product.
4. The product is compatible with up to four capsules at one time.
5. Visit the manufacturer’s website or consult the capsule manual for further information.

Working Life of your Halo Remote
The operating range of the Halo Marker Pole System depends on various factors such as the terrain over which it is being used, the prevailing atmospheric conditions, and the presence of any interfering signals. The product is designed to work over long distances. However, it is recommended to refer to the Working Life section of the instruction manual for further information on obtaining the best performance from your Halo Remote.

Drying Out After Use in Heavy Rain
The product is weatherproof, but after use in heavy rain, it is important to bring the unit indoors and allow it to dry fully before using it again. Do NOT place batteries in a hot environment (e.g. on a radiator).

Battery Requirements
The Illuminated Marker Poles require 2 x LR03 AAA 1.5V alkaline  batteries. The use of good quality batteries is essential for  maximum battery life. Please ensure the batteries are removed from the remote during long periods without use.

Warnings

FOX, I-Com, and Halo are Registered Trade Marks. We reserve the right to alter or modify the contents of this manual. Hereby, Fox International Group Ltd, declares this Halo IMP Remote is in  compliance with the essential requirements and other relevant provisions of the UK Radio Equipment Regulations 2017. The full
text of the UK declaration of conformity is available at the following internet address: www.foxint.com/home/support/declarations-of- conformity/ Registered Designs and Patents Pending.

Features

• Weatherproof Sealed Unit
• Easy Registration
• Very Low Battery Drain
• I-Com® Technology
• Digital Circuitry
• Lanyard Attachment

Product Operation

Register with Capsules:

• Once the “registration mode (indicating it is in the “registration mode”), the preferred button on the Remote is pressed – Registering the selected button on the Remote to the Capsule.
• Repeat the process for additional Capsules.

Led On/Off

• A single press of a button on the Remote will make a registered Capsule LED turn on (first colour in the sequence if a colour has not been previously selected on the Capsule).
• A single press of the same button will turn the LED off.

Please Note:
(The Remote has been design to have a very low battery drain, and a new set of batteries will last for long periods – Please refer to the “Working Life” section of the instruction manual for further information).

Compatibility (I-Com®)

Your Halo Remote contains an advanced transmitter device, capable of long distances, this is only compatible with the Halo Capsules. Up to four Capsules can be used at one time with the Remote.
Please visit our website or consult the Capsules manual for further information.

WORKS EXCLUSIVELY WITH THE HALO CAPSULES
NOT COMPATIBLE WITH OTHER EXISTING FOX PRODUCTS

Fitting the Batteries

1. Using a cross head screwdriver, unscrew the two battery cover screws.

2. Pull the lower edge up and slide back to remove the battery cover.

3. Take care removing the batteries. Insert new batteries and ensure correct polarity.

4. For best weatherproofing, ensure the battery cover has a good seal by firmly pushing the lip into the top edge of the case, and pivoting it into position.

5. Re-ht battery cover and screws.

DO NOT over tighten the battery compartment screws, excessive force will damage the screw threads.

Working Life of your Halo Remote

Your Halo Remote has been designed to have a very low battery drain.
You can expect your Halo Remote to have the following “Working Life” duration when new batteries are used:

• Standby Mode = 833 days (Remote is powered, but not in active use – Buttons not pressed)
• Operational Mode = 13 hours (Remote life in constant active use – Approx. equal to 46,800 button presses)

Obtaining Best Performance from your Halo Remote
The operating range of the Halo Marker Pole System, like all low power radio systems, is of both transmitter and receiver, the terrain over which it is being used, the prevailing atmospheric conditions and the presence of any interfering signals.
To obtain best performance, it is recommended that you –

• Operate the Remote as high above ground as possible – If worn on the body, it should be worn as high as possible and on the outside of your clothing.
• Try to keep a direct “line-of-sight” between the receiver and transmitter when in use – obstruction such as trees etc. may cause loss/reduction of signal.
• Do not keep the Remote in the same pocket as a mobile phone, or other electronic devices.
• Ensure both the Capsule and the Remote have good batteries.

All the above hints become progressively less important, as the working range is reduced.

Drying Out After Use in Heavy Rain

Your Remote has been designed to be weatherproof. However, after use in heavy rain, it is important to allow the unit to dry out properly by bringing the unit indoors and allowing to dry fully after use.
NEVER place batteries in a hot environment (e.g. on a radiator).

Battery Requirements

Your Halo Remote requires 2 x LR03 AAA 1.5V alkaline batteries.
The use of good quality batteries is essential for maximum battery life.
To reduce the risk of battery leakage:

• DO NOT mix old and new batteries
• DO NOT
• The use of rechargeable batteries is NOT recommended

Please ensure the batteries are removed from the Remote during long periods without use.

Warnings

• Avoid using powerful radio transmitting equipment in close proximity to the
• Store this equipment out of reach of children and infants.
• Avoid dropping or subjecting the Remote to severe impacts.

Product Information

FOX, I-Com, and Halo are Registered Trade Marks.
We reserve the right to alter or modify the contents of this manual.
Hereby, Fox International Group Ltd, declares this Halo IMP Remote
is in compliance with the essential requirements and other relevant provisions of the UK Radio Equipment Regulations 2017.
The full text of the UK declaration of conformity is available at the following internet address:
www.foxint.com/home/support/declarations-of- conformity/
Registered Designs and Patents Pending.

• Operating frequency = 434MHz
• IP Rating: IPX5

References

• Fox: Carp Fishing Tackle, Rods, Reels, Clothing And More
• Declarations of conformity
• Documents contractuels
• Declarations of conformity
• Documenti regolamento
• Keurmerken
• Dokumenty Regulaminowe
• Documente reglementare

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>